How Does the Gooseneck Coupler Head Kit # GC-HEAD Install

Question

Question:

Do you have installation instructions for GC-HEAD?

asked by: Evan

0

Expert Reply:

I have included a picture showing how the parts of gooseneck coupler # GC-HEAD go together. They would be welded to the coupler tube in this configuration. Welding should be done by a professional welder. There are no specific instructions for the install.

expert reply by: Michael H

0

click to enlarge

Answer 1

Hi Jay, yes, the part #TJD-12000-HD jack handle is compatible with the part #TJDDP-20000SP-F jack. Although our product page lists the handle for the 12,000 lb RAM jack, it is the same handle used on the etrailer 12,000 lb jack. We currently do not…

view full answer...

Answer 2

We have the Buyers Products Heavy-Duty 4" Square Jack w/Front Pin Drop Leg #3370091415H that matches the design of the jacks on your gooseneck trailer. We will only have the jack assemblies and will not have the crossover tube or handle…

view full answer...

Answer 3

The Square Direct Weld Jack #TJDDP-20000SP-F will need to be welded on to the trailer frame by an experienced welder. So if you're using this to replace an old jack then you'll need to cut off the old jack and have this installed by welding.…

view full answer...

Answer 4

I reached out to the company that builds the Ram Gooseneck Coupler item #GCSQTW-30008 , Pacific Rim International Factory, and was not able to get an exploded parts diagram. I have listed all of the replacement parts below that are available.…

view full answer...

Answer 5

Hey Russell, I'm assuming you're talking about a surge actuator. So to test to see it's bad or not, or if it's your truck, you can jack up one side of the trailer and spin the wheel while someone manually activates the surge actuator…

view full answer...

Answer 6

ICC stands for Interstate Commerce Commission. An ICC light is on a switch, though it could also be wired into another circuit such as the running lights. It is basically so that when you flip the switch the marker lights will flash. Typically this…

view full answer...

Answer 7

The Bulldog coupler part #BD028499 is the same angle as the Atwood coupler you had so it would fit right up to your trailer and work well.

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

Your issue is actually pretty common and has been written off as normal by GM so a warranty replacement likely won't be an option. There's quite a few forums where others with this puck system have switched over to the B&W Ball and Safety…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

How Does the Gooseneck Coupler Head Kit # GC-HEAD Install

Product Page this Question was Asked From

Continue Researching