Replacement 12,000LB Landing Gear Jacks For 30' Gooseneck Trailer

Question

Question:

Do you offer a direct replacement for 12k weld in tandem jacks . All parts included? the entire jack system will needs to be replaced.

asked by: Wayne R

0

Expert Reply:

We have the Buyers Products Heavy-Duty 4" Square Jack w/Front Pin Drop Leg # 3370091415H that matches the design of the jacks on your gooseneck trailer. We will only have the jack assemblies and will not have the crossover tube or handle extension. If those parts are also needed they will need to be fabricated from steel tubing you can get at your local steel supplier.

expert reply by: Bud M

0

Gooseneck Trailer With 12K Landing Gear Legs
(click to enlarge)

Answer 1

Hi Jay, yes, the part #TJD-12000-HD jack handle is compatible with the part #TJDDP-20000SP-F jack. Although our product page lists the handle for the 12,000 lb RAM jack, it is the same handle used on the etrailer 12,000 lb jack. We currently do not…

view full answer...

Answer 2

I have included a picture showing how the parts of gooseneck coupler #GC-HEAD go together. They would be welded to the coupler tube in this configuration. Welding should be done by a professional welder. There are no specific instructions for the…

view full answer...

Answer 3

The Square Direct Weld Jack #TJDDP-20000SP-F will need to be welded on to the trailer frame by an experienced welder. So if you're using this to replace an old jack then you'll need to cut off the old jack and have this installed by welding.…

view full answer...

Answer 4

Hey Ashley, we do have that! The Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 4" Wide #D4-96 is available, and we have a few others that you can view here; https://www.etrailer.com/dept-pg-Trailer_Door_Parts-pt-Bumper_Strip.aspx…

view full answer...

Answer 5

Hello Sandi, Thank you for sending over the pictures. They were very helpful in confirming the correct replacement. Based on the photos, the Lippert Replacement RV Slide-Out Venture Actuator with 18:1 Motor, 24" Long #LC119128 will work as a…

view full answer...

Answer 6

I might have an option for you but I don't know what exact jack you have on your Exiss Horse Trailer. That said, they are usually welded so there's not really a bolt-on replacement. The Buyers Products Heavy-Duty 4" Square Jack part…

view full answer...

Answer 7

Hey Bama, the correct replacement standard slam latch for the Bauer BP12-ETP is the part #BA64FR but we don't have a version that has a key pad installed on it.

view full answer...

Answer 8

The only place that you would be able to get any kind of parts for the Bauer Products Motorhome Door Lock #BA64FR would be from Bauer Products directly. Most likely though with the issue you described they'd just tell you to replace the entire…

view full answer...

Answer 9

Hi George, The Curt Replacement Lifting Nut part #C93NR is specifically designed for the Curt 28512 heavy-duty weld on jack so it will not work as a replacement for a Bulldog jack. Bulldog jack parts are typically model-specific so even if they look…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement 12,000LB Landing Gear Jacks For 30' Gooseneck Trailer

Product Page this Question was Asked From

Continue Researching