4-Way Trailer Wiring Recommendation for 2002 Isuzu Rodeo

Question

Question:

HI first Id like to thank you for you time to answer my question. Ok I have a 2002 Isuzu Rodeo and I want to install a 4way trailer conception. But I only see a connecter with 2 wires one hot and on ground I believe they are the running lights located on the drivers side between the rear wheel and the bumper on the inside of the frame. But I cant seem to find wher to concept the stop and signal wire. Would you have this info? Once again thank you for any help you can help me with

asked by: Santos V

0

Expert Reply:

For your 2002 Isuzu Rodeo the trailer kit I would recommend is the T-One kit part # 118360 which is a confirmed fit and installs by plugging inline with the vehicle taillight connectors. I attached an install video for this kit on a similar 2001 Isuzu Rodeo for you to check out as well.

expert reply by: Jameson C

0

Answer 1

You will first want to check the fuses on your tow vehicle. Some vehicles could have fuses for operating the turn signals and brake lights of a towing package. You will want to check if they are installed and working properly. The next thing is to…

view full answer...

Answer 2

It sounds like you're trying to add a 7-way trailer connector on your 2005 Chevrolet Colorado. We certainly have the parts you need but depending on what you have as to which route you need to go. If your truck has the tow package and is equipped…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 11

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 12

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

4-Way Trailer Wiring Recommendation for 2002 Isuzu Rodeo

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching