Winch to Replace Fulton T600 Fulton Winch

Question

Question:

Will this winch spring#4769-28 fit my older Fulton T600 winch? Please reply. Thank you.

asked by: Kevin

0

Expert Reply:

Unfortunately, Fulton no longer has a service kit for the T600 winch.

Instead I recommend replacing the winch with the Fulton # F142002. It's actually a replacement to the T600 with a higher capacity.

expert reply by: Adam R

0

Answer 1

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 2

The beveled gear kit that you referenced, #F0933302S00, is designed for Fulton jacks with weight capacities ranging from 800 to 1,200, so this should be the correct set for your 1,000 pound model. This kits is designed for use with Fulton jack models…

view full answer...

Answer 3

Unfortunately, Fulton no longer has a service kit or spring for the T600 winch. Instead I recommend replacing the winch with the Fulton #F142002. It's actually a replacement to the T600 with a higher capacity.

view full answer...

Answer 4

I do have some replacement trailer axle options for you but in order to determine the correct replacement you'll need to measure the length which is done from the face of each hub. This when combined with the capacity can then be used to…

view full answer...

Answer 5

We don't have a way to look up exactly what axle you need based on what you listed but we can still help. When picking out an axle for a trailer you'll need to know the overall length of it from hub face to hub face as well as the distance…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Winch to Replace Fulton T600 Fulton Winch

Continue Researching