Replacement Gear Kit for Fulton Trailer Jacks with 1,000 Pound Weight Capacity

Updated 06/03/2015 | Published 06/02/2015

Question:

What rebuild kit do I need for a Fulton trailer jack 1000 # Capacity. How hard is it to change the gears out

asked by: David W

Expert Reply:

The beveled gear kit that you referenced, # F0933302S00, is designed for Fulton jacks with weight capacities ranging from 800 to 1,200, so this should be the correct set for your 1,000 pound model. This kits is designed for use with Fulton jack models TJ503/C, TJU503, PMJ53, TJ507/C, PMJ75, CS750, GR700/TJ712, XP10/6/W/WC and XP100.

Installing the gears is fairly easy, You will need to remove the cap at the top of the jack. The handle and gear are held in place with a roll pin. Remove the pin. You can then remove the handle, square block and gear. Remove the bottom gear by lifting it out. If the bottom roll pin is damaged remove it. The washer can be replaced after removing the lower pin. When replacing the bottom gear on the roll pin be sure the slotted portion of the gear is in the closed end groove that will not allow the pin to come out of the side of the gear. Reassemble in reverse order.

expert reply by: Chris O