Bottle Jack Recommendation for Supporting Yakima Rack and Roll Trailer to Change Spare

Question

Question:

I am looking for a jack that can be used on the side of the road to lift a yakama trailer on the wheel sides to change a flat. If any that makes sense. A wheeled swivel jack will not work for tire change applications.

asked by: Paul M

0

Expert Reply:

The only type of trailer jack we can recommend for changing a trailer spare is a bottle jack like the part # ALL640405 which would work well with your Yakima Rack and Roll trailer like part # Y08107.

expert reply by: Jameson C

0

Answer 1

Hey Michael, The wheel for your Yakima Rack And Roll Kayak Trailer #Y08106 would be held in place with a single bolt. The bolt head would stick out past the wheel so you should be able to use another wrench to hold the bolt while you torque down the…

view full answer...

Answer 2

Yes. You can get the tire #Y8880282 you referenced and inner tube #Y8880283 if you want the spare parts but you can also replace a complete wheel with the Spare Tire with 5 Spoke Rim for Yakima Rack and Roll Trailer #Y08121. A 2 pack of these wheels…

view full answer...

Answer 3

We actually made a video that covers the assembly of Yakima Rack and Roll trailer part #Y08106 you mentioned that you can use as a guide. Check out the attached link to this page.

view full answer...

Answer 4

I checked the install instructions for the Yakima Rack and Roll Trailer part #Y08107 that you referenced and found the following torque figures: Wheel axle nuts (2) – torque to 57 ft. lbs. (77N-m) (a force of 57 lbs. on a 1 ft. lever.) Swingarm nuts…

view full answer...

Answer 5

Hey Kurt, thanks for reaching out. We do have a disc brake conversion kit that will work great for your 2020 Grand Design Momentum 399th with triple Dexter 7658660 axles. For that I recommend the following: - DeeMaxx Disc Brake Kit w/ Actuator for…

view full answer...

Answer 6

Hello Gary, thanks for reaching out. The Power Mountain Tallboy Off-Road Bottle Jack #PM34FR has a lift (throw) range from 8.5 inches to 37.75 inches. So whatever you’re planning to lift with it, you’ve got plenty of headroom and reach based on that…

view full answer...

Answer 7

Hey Lyn, a rear sway bar is definitely going to help with the handling of your 2013 GMC Sierra 2500 that has a Lance Camper 825. Since that's a pretty large camper I would go with a thicker sway bar as the thicker the bar the more it will prevent…

view full answer...

Answer 8

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Bottle Jack Recommendation for Supporting Yakima Rack and Roll Trailer to Change Spare

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching