Dimensions of Replacement Red Lens for Wesbar Submersible Trailer Tail Lights # 102641

Question

Question:

What are the dimensions of your trailer replacement lens Item 102641.

asked by: Steven

0

Expert Reply:

The Replacement Red Lens for Wesbar Submersible Trailer Tail Lights # 102641 that you referenced measures 8 inches wide by 2-13/16 inches tall.

I attached a picture that shows it's dimensions as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

For a set of replacement lenses for the Wesbar lights associated with the replacement capsule 763560 that you have referenced you would need to use #053522033360. This also includes the smaller side lenses. The larger lenses measure 8 inches by…

view full answer...

Answer 2

Yes, the Wesbar Replacement Lens Set, #053522033360, does contain the large lens, #102641. If you just needed the large lens, the you can purchase it individually, see attached product link.

view full answer...

Answer 3

The #102641 is only the larger lens. For the large lens and side lens you would need the Wesbar Replacement Lens Set #053522033360.

view full answer...

Answer 4

Thanks for reaching out! You are correct that the SAE number isn't the part number for the trailer light. It stands for Society of Automotive Engineers and is just a way of showing that the light manufacturer completed the required testing for…

view full answer...

Answer 5

I pulled a Wesbar Replacement Lens Set #053522033360 and found that the outer dimensions are the same as your lenses. 8 inches by 2-7/8 inches. And even the long dimension of the bolt holes is the same at 7-1/4 inches, but the shorter distance is…

view full answer...

Answer 6

The replacement red lens for your Wesbar tail light is part #102641. For a Wesbar Replacement Lens Set, see part #053522033360. This also contains the large lens, #102641.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Dimensions of Replacement Red Lens for Wesbar Submersible Trailer Tail Lights # 102641

Continue Researching