Is the Rampage SuperBrite LED Tailgate Light Bar Part # RA960134 DOT Approved

Published 03/07/2018

Products Featured in This Question

Rampage SuperBrite LED Tailgate Light Bar - Stop, Tail, Turn - 4-Pole Flat - 60" Long

(75)

$98.99

Hook Probe Circuit Tester

(70)

$12.41

Self-Stripping Connector with Waterproof Sealant - 14-18 Gauge - White and Blue - Qty 1

(47)

$2.23

Question:

If these plug into the 4 way connector then I will have unplug them every time I pull my trailer? Is there another solution or am I not understanding something?

asked by: Bob

Expert Reply:

I spoke to my contact at Rampage and they were able to inform me that the Rampage SuperBrite LED Tailgate Light Bar part # RA960134 is approved by the department of transportation (DOT) in all states. Therefore, you will not need to worry about getting pulled over because of the light bar that is.

The light bar is very easy to install. All you need to do is plug the 4-way trailer connector on the light bar into the 4-way trailer connector on your vehicle or cut off the connector and splice into the factory lights. You can then remove the adhesive backing and apply.

expert reply by: Conner L

Bob

3/7/2018

If these plug into the 4 way connector then I will have unplug them every time I pull my trailer? Is there another solution or am I not understanding something?

Conner L.

3/7/2018

If you want to use the light bar at the same time you will be pulling a trailer, then you will need to cut off the 4-way trailer connector that came with the light bar and wire it into the factory lights on your truck. You can do this by using both a circuit tester like part # PTW2993 and quick splice connectors like part # SWC501746-1.