Wheel Lock for Spare Tire and 1/2"-13 Threaded Stud

Question

Question:

I have a Casita trailer with a spare tire on the back held in place with a regular 1/2 inch bolt with 13 threads per inch. I am looking for a locking type lug nut for the bolt to prevent thieves from taking the spare. Have anything?

asked by: Ron D

0

Expert Reply:

We have spare tire lock # FSTL0603 that you could use. It works with wheel studs up to 9/16 inches. I have included a link to a video review of this lock for you.

expert reply by: Michael H

0

Answer 1

I am happy to help you troubleshoot the 12v pin not getting power on the 7-way connector. On some Fords with factory brake controllers, the 12V pin does not show power unless you are testing it with a trailer connected. Please make sure it is a…

view full answer...

Answer 2

I've looked through our spare tire locks, and have seen that we don't offer one that uses a J-bolt. Fulton offers an inexpensive carrier/Lock solution, part #FETCSTL0701 that would allow you to attach and lock a spare tire onto your trailer…

view full answer...

Answer 3

Hey Ron, the Replacement Converter for your Magnetek Converter Series 6300 Model 6332 is going to be the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 35 Amp item #PD4635V. It being rated a couple amps higher will not be an…

view full answer...

Answer 4

Hello Kyle, thanks for reaching out. We do offer a replacement for the Magnetek 6336 converter. For that, you will want the following: - Replacement Section for AC/DC Power Distribution Panel - 35 Amp #PD4635V This can work with flooded lead acid,…

view full answer...

Answer 5

There's not an option to upgrade just the converter on your power center if you are wanting to use lithium batteries. I say this because most people who upgrade their converters on the Magnetec series 6300 do so to change over to lithium…

view full answer...

Answer 6

I don't recommend using a higher amp converter as the converter size is based on the load of the trailer and there would be no real benefit of going with an overrated option. That said, if you want to go up 5 amps or so that shouldn't really…

view full answer...

Answer 7

Hey Chuck, we have wheel/tire combos that will work for you but it will be based on the bolt pattern of your wheels. Most likely you have a 5 on 4-1/2 inch bolt pattern and the part #AM31994 would work great but if you have a 4 on 4 inch bolt pattern…

view full answer...

Answer 8

I believe you are asking about the minimum roof thickness needed to install the MaxxFan Deluxe Roof Vent with 12V Fan, Thermostat, and Remote #MA00-07500K. The answer is that you need a roof which is a minimum of 1-1/8 inches thick. To install this…

view full answer...

Answer 9

The LaSalle Bristol XTRM Universal Sealant part #344270341437-1 is a universal sealant we use on RV's in our shop for all sorts of project such as sealing cable pass-throughs walls/floors. It's great to keep one of these in the trailer for…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Wheel Lock for Spare Tire and 1/2"-13 Threaded Stud

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching