Bolt Hole Spacing of the Curt Front Mount Trailer Hitch Receiver Part # 31026
Updated 02/19/2018 | Published 02/17/2018
Question:
Curt 31026, would like the mounting hole center dimensions fore and aft and left to right. Any pictures of installs on Ford F150/250 would be helpful if you have any. Thank you
asked by: Gregory
0
Expert Reply:
I went out to our warehouse and measured the Curt Front Mount Trailer Hitch Receiver part # 31026 for you. The distance between the bolt holes on center is about 37" left to right and 4-1/4" front to back. I have attached a photo with these measurements listed for you in addition to a photo of the hitch installed on a similar Ford F-150.
expert reply by:
Conner L
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Concealed Cross Tube
- 500 lbs Vert Load
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Front Mount Hitch
- Article: Stability Control for Heavy Duty Vehicles
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Is there a Hitch-Mounted Winch Mounting Plate for a Warn 8274 Winch
- Q&A: 10k Tow Loop Needed With Minimal Play In The Receiver Tube
- Q&A: Meyer Snow Plow - Differences Between The Models In The Lineup
- Q&A: Should Trailer Be Exactly Level When Being Towed?
- Q&A: Replacement Hitch Mount Recommendation for Older Snowbear Plow that Fits 2 inch Hitch
- Q&A: Replacement Cover for TruXedo TruXport on 1992 Ford F-150 Long Bed