Fitment of the TorkLift HiddenPower Under-Vehicle Battery Mount Part # TLA7730

Question

Question:

Will this work on a 2005 extended cab 4x4 silverado 1500 LT

asked by: J.D.

0

Expert Reply:

The TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box part # TLA7730 is not a direct fit for your 2005 Chevrolet Silverado 1500 though there may still be a may for you to make it work for you. Unfortunately, the only battery box kits we have are for 2500 and 3500 models.

expert reply by: Conner L

0

Answer 1

The ShockStrap Ratcheting Tie-Down Kit w/ Built-In Shock Absorbers - 2" x 9' #297-9RSDB will work very well for your compact backhoe with loader. Using four straps for one backhoe/loader will work well. The majority of the weight will be on…

view full answer...

Answer 2

Hey Jill, are the brakes on the surge trailer coming off and on possibly and that's what your feeling? That would be a bad shock in the surge actuator which we can help with if we know which actuator you have.

view full answer...

Answer 3

Since hitch extenders like the 11" Roadmaster #RM-071 you show in your pictures reduces the weight rating of the hitch by 50% we typically recommend avoiding them as a solution. For your application we have ball mounts with extended shanks that…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Fitment of the TorkLift HiddenPower Under-Vehicle Battery Mount Part # TLA7730

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching