Replacement Mounting Hardware for Westin E-series Bull Bar on a 2008 Toyota Tundra

Question

Question:

Looking for replacement mounting hardware for my 2008 Toyota Tundra crewmax can you give me the part number or link to it thanks pieces that mount where tow hooks mount thanks westin e series.

asked by: Kelton

0

Expert Reply:

The replacement bracket kit for the Westin E-Series Bull Bar part # 31-5250 on your 2008 Toyota Tundra is the Replacement Mounting Hardware for Westin E-series Bull Bar with Skid Plate part # 31-525PK.

expert reply by: Conner L

0

Answer 1

With bull bars and their installation kits such as #31-595PK both the bar part AND the installation kit are vehicle-specific. In other words, you must have the correct bar and the correct installation kit for any given vehicle. You cannot install the…

view full answer...

Answer 2

Hey Gary. The Draw-Tite Front Hitch item #65031 is going to mount a bit higher on your 2004 Toyota Tundra compared to the Curt item #31180. The Curt Front Hitch item #31180 is 14-3/4" off the ground when measured from the top of the inside of…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 6

Hello Alfredo, thanks for reaching out. You are on the right track with the 25-1/4" long 4,000 lb leaf spring part #e57SR. That sounds like exactly what you need size and capacity-wise. I wouldn't worry about any excessive bounce with those.…

view full answer...

Answer 7

The brake controller port for the 2015 Toyota Tundra is located behind the section of the dashboard with the tow/haul button. To reach the connector you will need to locate the notch in the access panel in the center of the dash near the driver's…

view full answer...

Answer 8

Hey Steve! I just heard back from Dexter and you have a 3,500 lb axle. For self-adjusting brakes you can use the etrailer Electric Trailer Brakes #AKEBRK-35-SA. If you prefer Dexter brakes then you need the Nev-R-Adjust #23-468-469. For bearings and…

view full answer...

Answer 9

Hey Brian! Yes, the Firestone Ride-Rite Air Helper Springs #F89VV will fit your 2025 Toyota Tundra. That is just the generic picture attached to that page, I can see how it would be confusing. These are designed to mount over the axle, and are…

view full answer...

Replacement Mounting Hardware for Westin E-series Bull Bar on a 2008 Toyota Tundra

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching