Will B&W Tow & Stow 2-Ball Mount BWTS20040B Fit a Class V 2-1/2-Inch Hitch  

Hitch pins don't actually bear any of the weight of the trailer so they are not rated for trailer weight like what you are referencing. The tongue weight of the trailer pushes so hard down on the hitch tube that it binds it up in the hitch…

Yes, for the B&W Tow & Stow, I recommend the Trailer Hitch Receiver Lock for 2", 2-1/2", and 3" Hitches #C23025.

I do have a great option for you, however we do not have any standard 3,500 pound round tube axles available that match the dimensions you provided. For an exact replacement your best option will be to go through a local trailer shop or the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

There is a way for you to not only lock the B&W Tow & Stow 3-Ball Mount - Compatible with GM MultiPro Tailgate - 2.5" Hitch - 148K #BWTS20067BMP to your 2-1/2 inch trailer hitch, but also the ball platform to the mount, and the hitch…

Thank you for the photos and sorry to hear about your truck! The unique design of the B&W Tow & Stow 2-Ball Mount - Compatible with GM MultiPro Tailgate #BWTS20066BMP is that angled section that meets with the shank part of the ball mount. On…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hi Robert, The Curt Pintle Hook #C45908 would require that your EZ Loader boat trailer has a lunette ring for the coupler. From what I can see the 26-30ET should have a surge brake coupler that would couple to a standard ball mount. You'll need…

The answer to your question will depend on the trailer hitch receiver on your truck. From what I have found, the Rock Tamer mud flaps require minimum 1" of space in order to be able to mount them. I reached out to B&W and the distance from…