Where Does Brake Controller Install Port Attach on 2017 Ram 3500

Question

Question:

I have a ram 3500 2017! How does the brake switch looks like under the dash? Y need to conect my P3 tekonsha brake controller thanks

asked by: Manuel Q

0

Expert Reply:

To install the Prodigy P3 brake controller part # 90195 in your 2017 Ram 3500 will require the install harness part # 3024-P which will be located underneath the dash and right of the steering column, taped to another harness. There will be a 4-pin connector that mates with the one on the adapter.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Even if you don't have the factory brake controller installed on your 2017 Ram 1500 you shouldn't need to get it flashed to activate the controller. All you would need is the Prodigy P2 #90885 and the wiring adapter #3024-P that you saw in…

view full answer...

Answer 2

Factory brake controllers seem to unfortunately be very temperamental and usually quite a bit more expensive that an aftermarket brake controller so I have to recommend going with an aftermarket option. Luckily there is a brake controller port so…

view full answer...

Answer 3

For the Demco EZ Latch Coupler like item #DM37ZR that does not have a lip around it you would want the Fastway Universal Trailer Coupler Lock item #DT25013KA. This is by far the best and most compatible option of the ones you listed. If you have more…

view full answer...

Answer 4

We've spoken with Tiffin in the past about where to find the brake controller install wiring for your Phaeton 40AH and they told us that under your driver side dash there are 4 wires that have butt connectors on them. They are labeled by…

view full answer...

Answer 5

Good day Brooke! That's a valid question as we just started carrying the Aluma-Tow ball mounts (Aluma-Tow 360 Adjustable 2-Ball Mount - 2" Hitch Silver #UR45PR and Black#UR95PR). They are very comparable in quality to the Trimax Adjustable…

view full answer...

Answer 6

Hey Cory, thanks for reaching out! I'd be more than happy to help you get your 1999 Dodge Ram 2500 set up for trailer towing! Here are the parts you'll need: - T-One Vehicle Wiring Harness #118329 - Universal Wiring Upgrade #ETBC7 - Mount…

view full answer...

Answer 7

Hey Chandler, brake controllers like the Redarc Tow Pro Liberty part #RED52VR can basically be installed on any vehicle so you can definitely install it in your 2012 Toyota Sienna. Redarc probably left your vehicle off since it's a little older…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The Tekonsha Prodigy P3 Brake Controller, #90195, does not have an on and off switch. It will go into sleep mode after several minutes of no activity. The power draw when it is in the sleep mode is so negligible that it will not discharge the…

view full answer...

Answer 10

As you may have already found, 5200 lb, 6000 lb and 7000 lb axles can all use the same components including inner/outer bearings, hubs and brakes. Here are some other things they share in common: Dexter 5200 lb Regular Duty Axle - 0.180 inch tube…

view full answer...

Where Does Brake Controller Install Port Attach on 2017 Ram 3500

Continue Researching