Installation of Lippert Electric Steps # LC369552

Question

Question:

Lc369552. What is 9510 any other parts needed to install steps are motor and control unit included

asked by: Bob

0

Expert Reply:

The Lippert Kwikee 24 Series Electric Steps - 3 Steps - 7" Drop/Rise - 24" Wide - 300 lbs # LC369552 simply need the hardware kit # LC118155-72 to bolt into existing mounting hole locations.

This unit includes the logic control unit, the door switch kit, and the motor assembly. It will have all the parts you need. To specifically answer the part number question, the Lippert 9510 is the control unit for the step that is included. We have this available as a separate piece for other steps as # LC379146.

expert reply by: Jason S

0

Dave R.

2/21/2020

Why does this say it is 30 wide which doesnt match any of the actual dimensions shown? RV and Camper Steps Motorhome Electric Step 30 Inch Wide 300 lbs 3 Steps 7 Inch /Rise No Ground Contact Steel Kwikee

Chris R.

2/21/2020

Thanks so much for the feedback. You are correct that the Lippert # LC369552 is a 24" wide step assembly, not 30". We simply had it listed under the wrong size category and it will be updated/corrected shortly.

Answer 1

The Replacement Magnetic Door Sensor for Kwikee Electric RV Steps #LC374198 is a "normally closed" switch, so it would not be the correct switch to use with the Replacement Control Unit for Kwikee Electric RV Steps #LC379146 if you are…

view full answer...

Answer 2

Did replacing your controller solve the issue temporarily or were the steps still closing when the door is shut? If there was no change the control module isn't the cause of the issue. Typically a bad ground connection can cause steps like these…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 10

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Hello Joe, Thank you for reaching out! The Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons #PM94FR does have the capacity you’d need, but since your fifth wheel’s frame sits about 25" off the ground,…

view full answer...

Installation of Lippert Electric Steps # LC369552

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching