What is Capacity of Fulton Fold-Away Coupler Hinge Kit # FHDPB230101

Question

Question:

Is this a 9000 lb rated bracket?

asked by: Billy

0

Expert Reply:

The Fulton Fold-Away Coupler Hinge Kit # FHDPB230101 has a 5,000 lb trailer capacity. I attached a chart that breaks down it's capacity based on how you install it.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Hey Bryan, I can definitely understand your concern, though your trailer frame won't be damaged or otherwise put under undue stress by adding the Fulton Fold-Away Coupler Hinge Kit for 2" x 3" Trailer Tongue #FHDPB230101. That's…

view full answer...

Answer 2

In regards to the Fulton Fold-Away Coupler Hinge Kit part #FHDPB230101, Fulton does use the gross trailer weight rather than the actual trailer weight for their max pivot length. I can't recommend going against this but I would assume they are…

view full answer...

Answer 3

Hello Bob. Yes, installing the fold away behind the winch will not be an issue, main thing is to not go back further than what is recommended on the chart which goes by the Gross Trailer Weight Rating. I looked up the specs on the Continental JB127…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

What is Capacity of Fulton Fold-Away Coupler Hinge Kit # FHDPB230101

Continue Researching