Can Trailer Door Latch # L1883 be Opened from Both Sides

Question

Question:

Does this open from both sides?

asked by: Kathy

0

Expert Reply:

The Locking Stainless Steel Flush Door Latch, # L1883, has a threaded hole on the inside part in which you could insert your own knob so that it can be easily opened from inside. Another option is basically the same door latch that comes with the knob already in place. It is # L1833.

expert reply by: Michael H

0

Answer 1

Typically, the Junior Door Latch would install by routing or cutting out a 2-3/4 by 3-3/4 inch hole and would then either be bolted or riveted to the door through holes that would need to be drilled in the flange around the latch. The latch is meant…

view full answer...

Answer 2

It depends on how the old one is attached to the door but you will likely have to pry it off. If there are no visible fasteners there wouldn't be any other way. You would have to be very careful not to damage the door in the process. When…

view full answer...

Answer 3

We have a few options for door latches that might be good replacements for yours. There is the Bauer Products Manger Door Lock for Horse Trailers #BA95FR. This is designed for a vertical oriented door latch. We also have a horizontal opening style.…

view full answer...

Answer 4

If you instead went with the Junior Latch part #L1883 you could then use the knob part #4PLSP but there isn't a knob solution for the #N1980.

view full answer...

Answer 5

I went out to our warehouse to check on the "Junior" Locking Stainless Steel Flush Door Latch #L1883 you asked about. When locked, the latch will allow the spring loaded pin to move and latch into place. So it will allow you to lock the…

view full answer...

Answer 6

The "Junior" Locking Stainless Steel Flush Door Latch #L1883 does not come with mounting hardware. Since this door latch can be used for a variety of applications, the mounting hardware will vary depending on the material and thickness of…

view full answer...

Answer 7

I went out to our warehouse and measured the "Junior" Locking Stainless Steel Flush Door Latch part #L1883 for you. The distance of the outer surface area that houses the 4 bolt holes is 1/2" on each side and the distance the latch…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Can Trailer Door Latch # L1883 be Opened from Both Sides

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching