Length from Hitch Pin Hole To Larger Welded Shank on Curt Extender # C45796

Question

Question:

Can you tell me the distance from the pin hole to where the larger welded pice starts?

asked by: Dennis

0

Expert Reply:

I went out to the warehouse to take a look at the Curt Extender # C45796 referenced in your question. I measured a distance of right at 3-1/8 inches from the center of the hitch pin hole to where the larger 2 inch shank begins. I have included an image with this dimension labeled that you can also check out.

expert reply by: Chris R

0

click to enlarge

Answer 1

Hi Don, Hitch extenders place a lot of stress on the hitch because you're leveraging the weight further out so using one typically drops the capacity by 50% when towing. You'd be doing it in a parking lot situation where you wouldn't…

view full answer...

Answer 2

The front air dam on your 2023 Ford F-150 Platinum will actually need to be removed to be able to install any of the front hitches. So yes, the front air dam will no longer be operational once you have the EcoHitch Hidden Front Mount Trailer Hitch…

view full answer...

Answer 3

The Softride #SR25219 will be a good option for getting rid of the movement you are getting in your ball mount while towing. One of the big pluses with the #SR25219 is that it will lock in place to keep anyone from walking away with it. That being…

view full answer...

Answer 4

Hey Charles, it sounds like you are wanting to use the hitch lock part #SR25219 as just a hitch lock and not use the anti-rattle portion at all. This is doable and would work fine but over time you might damage the threads and it wouldn't be able…

view full answer...

Answer 5

Hey Gary, yes we have Torklift camper tie downs that fit your 2025 Ram 2500 short bed with the part #TL73NR. What kind of camper do you have?

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

As we do not carry the Atwood jacks, I cannot confirm the fitment without knowing the measurements. However, the bolt holes on the HappiJac Swing Out Extension Brackets #LC182496 will measure 7-1/4" between all the bolt holes, picture included.…

view full answer...

Answer 9

Hey Vincent, yes the swing out extension brackets part #LC182496 would work great for what you are looking for to get the additional width needed.

view full answer...

Answer 10

I spoke with my contact at Curt and he told me you can install the Curt Front Mount Hitch, #31049, on your 1998 Ford F-150 2WD as long as the frame of your truck matches the width of the bolt holes on the hitch. The frame width should be the same…

view full answer...

Answer 11

The Reese #RP45292 you'd looked at is exactly what you'd need. You'll need to cut the bar down to the 24 inch length, and you'd then install it in your 2-1/2 inch hitch to provide a 2 inch receiver for your cargo trailer. Once…

view full answer...

Length from Hitch Pin Hole To Larger Welded Shank on Curt Extender # C45796

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching