Can 3-Step RV Step Replace 2-Step Version
Published 10/25/2017
Products Featured in This Question
Question:
can not seem to find a good fit, came with HSM 2 stepfoot i would like 3 steps at about 7inch raise, looks like you have a good choice along with video which is a lot of help.On my trailer they welded brackets soit attachs on the sides at 25 1/2 inside is the fit i need all the ones im finding are at 27inch it appears Did HSM make these special??
asked by: Tim
Expert Reply:
When you go from the 2-step versions of the Hickory Springs steps to the 3 step the mounting brackets do get a bit wider. The part # LC432687 which is the three step version is about 2 inches wider which means you'd need to move your current outriggers or install new ones with the part # LC301704.
Product Page this Question was Asked From
Lippert Manual Pull-Out Step for RVs - Triple - 7" Drop - 25-3/4" Wide - Steel - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 27-1/2 Inch Wide
- 3 Steps
- 7 Inch Drop/Rise
- Steel
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Option For Replacing Atwood 8525-IV-DCLP Furnace
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Measure for Motorhome Steps
- Q&A: Triple Step Recommendation for a 2010 Springdale SRT
- Q&A: Mounting Measurements for Lippert Manual Pull-Out Step LC432690
- Q&A: Can The RV Holding Tank Heater # 372HTH-A Be Installed In The Underbelly With Insulation
- Q&A: Wiring the Replacement Motor Klauber A-300 Model
- Q&A: Replacement 3-Step Pull-Out Steps for Jayco White Hawk Travel Trailer
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Q&A: Looking To Replace Manual Bathroom Vent With Powered Vent
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: Rooftop Cargo Carriers
- Article: How to Install a Roof Rack
- Article: Can You Flat Tow a 2024 Ford Bronco?