Comparing the Draw-Tite and Curt Trailer Hitch for a 2004 Lexus ES 330

Question

Question:

Hello, I have a 2004 Lexus ES330. You folks show 2 hitches as fitting and both go around the exhaust. Which of the 2 provides the greater ground clearance? Thanks

asked by: Thomas C

0

Expert Reply:

Both the Draw-Tite # 36336 and the Curt # C12339 will essentially have the same ground clearance. When we installed the Curt option on a 2005 Toyota Camry we found the distance from the ground to the top of the inside of the receiver opening to measure 11-1/2". When we installed the Draw-Tite option on a 2006 Camry we found that same measurement to be 11-3/4". This difference could very well have to do with differences in the tire inflation or cargo in the rear of the vehicle as well so either option is viable.

Because of this I recommend going with the Draw-Tite option for 2 reasons: 1) We have had the opportunity to install this option on a 2005 Lexus ES 330 so you can use that as a reference and 2) The Draw-Tite hitch does not require the use of a support strap for non-trailer loads like the Curt option does.

If you let me know what you will be using the trailer hitch for I can make some additional recommendations for you.

expert reply by: Jon G

0

Answer 1

In my opinion, the Draw-Tite trailer hitch #36293 has a cleaner look than Curt hitch #C12339. I have included a picture showing the hitches side by side installed on a vehicle for you to compare. The Curt hitch has that bracket that goes beneath the…

view full answer...

Answer 2

Yes, the Curt Trailer Hitch Receiver #C13394 will fit your 2022 Lexus RX 350 L as long as it doesn't have the Twin-Tip Exhaust. As far as the rear door kick sensor is concerned, we haven't heard anything about that but it isn't uncommon…

view full answer...

Answer 3

I looked up the towing capacity of your 2005 Toyota Camry and found it to be 2,000 lbs. So as long as your trailer would weigh less than that when loaded you'd be good with the Draw Tite hitch part #36336 installed. Then for trailer wiring…

view full answer...

Answer 4

When it comes to the Curt Trailer Hitch Receiver #C23FR compared to the Draw-Tite Trailer Hitch Receiver #DR47FR for your 2020 Ford Escape there are a couple of differences between the two that I'll go over for you. The first is the style, with…

view full answer...

Answer 5

Though the Curt # C13409 and Draw-Tite #76271 are nearly identical to each other, there are a few subtle differences. First being where they sit once installed. The will both have the exact same height of 14-1/2 inches, but the Draw-Tite #76271 will…

view full answer...

Answer 6

Hey Ben, thanks for reaching out! The Curt Trailer Hitch Receiver #C13043 comes with a spacer, and one set of 4 bolts that you'll use whether you end up installing the spacer or not. Attached is an installation video of this on a 2018 GX 460 for…

view full answer...

Answer 7

Hey Jordan, to install the Draw Tite hitch part #24870 all you need is a 10 mm, 13 mm, and 14 mm wrench. You'll need a torque wrench too like the part #PT87ZR. No special tools or accessories needed!

view full answer...