Compatibility of Stromberg Carlson Trailer Cargo Carrier for A-Frame of Casitas 17 Foot Trailer

Question

Question:

Will this front shelf work on my 17ft. Casitas trailer.

asked by: Efren

0

Expert Reply:

The Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers - 300 lbs # CC-255 can be used on your 17 foot Casitas trailer as long as the frame height is between 3-1/2 and 6-1/2 inches. It is able to be mounted in many different areas so you cill have the ability to clear obstacles like weight distribution brackets and propane tanks. This shelf is able to be moved forward or backward on the mounts up to 7 inches in either direction. It will give you a clearance above the trailer frame of 29 inches and the tray is roughly 20 by 32 inches due to the taper on the front edge. It has a max weight of 300 lbs and multiple tie down areas to secure your cargo.

expert reply by: Jason S

0

click to enlarge

Answer 1

Hey Michael. The 1976A736 schematic would be the one you would use to install the Soft Start Kit for Coleman-Mach RV Air Conditioners item #CM56RR. However, it's designed specifically for Coleman-Mach Series 45000, 47000, and 48000 air…

view full answer...

Answer 2

Hey Ralph, for replacement slam latches I would recommend going with the Global Link RV Slam Latch part #295-000015 which will not come open when you are travelling and you can get them keyed alike so that you'd need only one lock for all of…

view full answer...

Answer 3

Hey Robert! The RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) is designed to replace the discontinued Atwood 31013. This has an adapter plate so it will mount in the same location and have a nice clean look. They also have a propane and…

view full answer...

Answer 4

Happy to help James, There are several ways to mount the TorkLift PowerArmor Locking Battery Box #TLA7700L depending on your trailer. The box does not use a specific bolt pattern in the bottom. Instead, it is designed to be mounted a few different…

view full answer...

Answer 5

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 6

I have a great solution for you that will not require adding a hitch to the trailer so you won't have to move the spare tire and mount. Take a look at the Stromberg-Carlson cargo carrier #CC-255. It mounts at the front of an A-frame trailer frame…

view full answer...

Answer 7

Hey Matt, sounds like the Mount-n-Lock SafetyStruts Universal Bumper Brackets - 4" to 4-1/2" - Qty 2 #MO34VR will work on your setup. It's universal and attaches to just about any RV rear bumper. I've attached an installation video…

view full answer...

Answer 8

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 9

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 10

Hi Donny; after looking at several videos of the trailer it does appear to have a 6 on 5-1/2 bolt pattern with ST225/75R15 tires. The Goodyear Endurance ST225/75R15 Radial Tire w/ 15" Eagle Aluminum Wheel #GY97QB will be a direct fit.

view full answer...

Compatibility of Stromberg Carlson Trailer Cargo Carrier for A-Frame of Casitas 17 Foot Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching