Replacement Bearings, Races and Seal for 1993 Coleman Destiny Pop Up Camper
Updated 08/08/2017 | Published 08/06/2017
Products Featured in This Question
Question:
Hi, my son in law has totally botched a wheel bearing job on a 1993 coleman destiny pop up trailer other wise i would just use the part nos. from those parts but i do not trust that they are correct so here i am asking for your help please. The factory nos. out of the parts manual are the following, grease seal#4714a2201,bearing and race pkg.#4716-1101. I will be doing both wheels so need parts for both. thank you so much, looking forward to doing business. hope you can find these bearings and related parts.
asked by: Rick R
Expert Reply:
I was able to locate the correct bearings, races and seal that correspond to the part numbers you provided in your question.
For bearings you will need the part # L44649 and for races you will want # L44610. Then for the grease seal you will use part # 13194.
You can also take a few quick measurements on the trailer spindle at various locations to verify that these are the correct replacement parts. I have attached an image that shows where these measurements should be taken. You are basically measuring the diameter of the spindle where the bearings sit to determine the inner diameter that is needed. I recommend using a digital caliper like # PTW80157, as the measurements will need to be exact.
I have also attached a couple of articles on trailer bearings and wheels that you might find helpful.
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.06 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: scissor jacks camper jacks
- Search Results: stabilizer jacks trailer jack
- Search Results: drop leg stabilizer
- Search Results: trailer hubs and drums
- Search Results: redarc trailer brake controller
- Search Results: 205/65~10 trailer tires and wheels
- Video: Comprehensive Review: Stabilizer Jacks
- Shop: Easy Grease Trailer Hub and Drum Assembly for 2K Axles - 7" - 5 on 4-1/2 - L44649 - Pre-Greased
- Shop: etrailer Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs
- Shop: Brake Controller
- Q&A: Recommended Wire And Circuit Breaker For 12V Pin On Trailer 7-Way Connector
- Video: A Closer Look at the Stabilizer Jack
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Custom Harness - Dash Knob - Up to 2 Axles - Proportional
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - Up to 2 Axles - Proportional
- Shop: Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 2
- Shop: Kenda 205/65-10 Bias Trailer Tire with 10" White Wheel - 5 on 4-1/2 - Load Range D
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Stabilizer Jack Replacement for 1993 Coleman Pop-Up
- Q&A: Will a 205/65-10 Tire Size Replace a 20.5x8-10 Tire on an Old Popup Camper
- Q&A: Recommended Tire Size Upgrade From Current 205/65-10 Tires
- Q&A: Can 205/65-10 Tires be Upgraded to a Larger Size For Greater Ground Clearance
- Q&A: Install Instructions/Manual for Redarc Tow Pro Liberty Brake Controller
- Search Results: ez lube grease cap trailer bearings races seals caps
- Video: A Closer Look at the Replacement Trailer Hub Bearing
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Video: Torflex Lift Kit Feature Review
- Video: Detailed Breakdown of the Grease Seal
- Article: How to Raise Your Travel Trailer Height
on Trailer Bearings Races Seals Caps
