Will the etrailer.com Landing Gear Set Replace Atwood Landing Gear on a 2003 Keystone Cougar

Updated 07/05/2017 | Published 07/03/2017

Question:

I have a 2003 Keystone Cougar with Atwood Mobile landing gear. Will your Part #RVLG-8000 fit my application?

asked by: Don M

Expert Reply:

If you are needing to replace the Atwood landing gear on your trailer then the Landing Gear Set # RVLG-8000 will most likely fit as it uses the standard weld stop locations. The inside to inside measurement of the weld stops is 15-1/2 inches. If that is the same as your current landing gear then this landing gear set will fit perfectly.

Since this set already has the gearbox installed you can either use your current motor that you pictured (provided that it is still in good condition) or if you need a new motor as well you can get a new one with part # LC142178. This motor will be compatible with Atwood landing gear sets as well.

I have attached some pictures that demonstrates where the weld stops are on the landing gear as well as some specs for the motor that I mentioned as well.

expert reply by: Jon G