Grease Seal Recommendation for Hub With Bearings L68149 and L44649

Question

Question:

2007 starcraft pop up model 2018 what grease seal is needed for the drum. inner bearing is a L68149 outer bearing is L44649.

asked by: Mike M

0

Expert Reply:

For a hub that has the bearing numbers L68149 and L44649 the grease seal you would want is the part # RG06-050.

expert reply by: Jameson C

0

Answer 1

Yes, the Grease Seal part #58846 that you referenced is double lip seal.

view full answer...

Answer 2

For a 4400-lb Lippert axle the most popular grease seal is part #58846. This is a double-lip grease seal with an inside diameter of 1.719-inches and an outside diameter of 2.565-inches. This seal is often used along with inner wheel bearing #L68149…

view full answer...

Answer 3

You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…

view full answer...

Answer 4

Thank you for providing the part number from your existing grease seal, part 16074-224. Based on my research I found that part #10-9 is an equivalent replacement part. I have also linked a helpful article and video concerning bearings and seals.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

I currently have four different self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes. You can choose from the following: -Terran Axle Electric Trailer Brakes #TX97ZJ (3,500 Axles) -etrailer Electric Trailer…

view full answer...

Answer 10

I sure can Blake! I just heard back from Dexter and both of your axles are 3,500 lbs capacity. That's all the information they were able to provide. Here are the replacement parts you've requested: Hub/Drums - 5 on 4-1/2 Lug Nut Pattern item…

view full answer...

Grease Seal Recommendation for Hub With Bearings L68149 and L44649

Product Page this Question was Asked From

Continue Researching