Will a Reese Pintle Hook Fit Curt Mount # C48323
Updated 06/08/2017 | Published 06/06/2017
Products Featured in This Question
Question:
Will a reese pintle with 4 hole mount spacing bolt up to this plate?
asked by: Don S
0
Expert Reply:
The hole spacing on the Curt pintle mount # C48323 is 3-5/16 inches on center side to side and 1-3/4 inches on center up and down. Pintle hook/ball combo # C48200 or regular pintle hook # C48215 have the same mounting pattern so they will work. If you already have a Reese pintle hitch then it would just need to have the same mounting pattern.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Pintle Hook Mounting Plate for 2" Hitches - 6" Shank - 8 Hole - 10,000 lbs
- Pintle Hitch
- Mounting Plate Only
- Adjustable Height
- 10000 lbs GTW
- 2 Inch Hitch Mount
- 8 Holes
- Standard Shank
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Power Locking Handle for Truck With Leer 100XR Camper Shell
- Q&A: Cross Reference Chart for Kodiak Trailer Disk Brake Pads to Automotive Applications
- Q&A: Where Is Factory Brake Controller Plug Located On 2010 Ford Explorer Sport Trac
- Q&A: Will Air Lift 1000 for 2025 GMC Acadia Fit 2025 Chevy Traverse
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Hitch Mounting Plate Compatible with Convert-A-Ball Pintle Hook Combo
- Q&A: Recommended Trailer Jack for 2017 Sure Trac Dump Trailer
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: How to Determine Correct Replacement Hubs for Trailer
- Article: Pintle-Hitches
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: My Trailer Hitch Doesn't Fit