Trailer Hub Seal Recommendation to Replace Chicago Rawhide Seal 12407  

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The dimension differences between your original seals and the replacements you referenced is small enough that the two sizes will still be interchangeable. Since both #34823 (a single seal) and #RG06-010 (a pair of seals) are the preferred double-lip…

You likely have 1/2 inch studs on the trailer hub. For 1/2 inch you will want to torque the lug nuts to 75 - 85 foot pounds. For 9/16 inch lug nuts torque them to 135 - 145 foot pounds. And for 5/8 inch lug nuts torque them to 175 - 225 foot pounds.

The correct torque value would depend on the diameter of the wheel stud (not the wrench size needed to remove the lug nut or bolt). • 7/16 inch stud- 55-65 ft-lbs • 1/2 inch stud 75-78 ft-lbs • 9/16 inch stud 95-115 ft-lbs These torque values hold…

In order to give you an exact torque specification for your trailer wheels, I would need to know the stud size in addition to the diameter that you provided. For example, the most popular 8" diameter wheel we sell with a 4 on 4" lug pattern…

The difference between the letter D in your ST175/80D13 and the R in the tire size of the Wheel and Tire ST175/80R13 part #AM31985 that you referenced is the tire construction. D stands for bias-ply which is a less preferred tire construction,…

I did some research and found that the 12194TC seal you said you have measures 1.250 inside diameter, and 1.979 outside diameter. The seal I recommend is part #34823. The dimensions listed for this seal are 1.249 inside diameter and 1.983 outside…

The 125255UC seal has a 1.249" ID and a 1.983" OD and for that our part #34823 will be the correct replacement.

Hey Matt, we have a topper from Fas-Top that fits the 8 foot long bed versions of the 2024 Ford F-350 with the part #FT63EV but the part #FT84MV only fits the short bed trucks and would not work for you. The Solo is just the topper whereas the…

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…

According to Malone, the correct replacement bearings for your Malone MicroSport Trailer #MAL25FR are the #L44649. If you would like the bearing kit that includes the inner and outer bearing, along with the grease seal and races, then we have the…

I have a solution for you, but we do not have a double lip grease seal with the exact measurements you specified. However I was able to find out that the GS-1250 DL that you mentioned has the following measurements: Inside Diameter: 1.249"…