How to Make Template to Determine Where MaxxAir Roof Vent MA00-06200K Would Install on Roof

Question

Question:

I am doing a van conversion on a 2000 Dodge Caravan. The roof ribs are pretty tight. Is it possible to get a template for the 14inch x 14inch inch opening I need to cut to see if this fan will fit? Is there somewhere to download one, or can I buy just a template or gasket to actually put on the roof to see where this will fit - if it will fit - before I order it? Thank you! I worked for Camping World as a customer service rep and these fans were by far the favorite of those customers who had tried both the Fantastic and the MaxxAir. So, when it comes time to buy I know what I want!

asked by: Becky B

1

Helpful Expert Reply:

We don't have a template we can offer but if you measure a 14 inch by 14 inch square you'll know where the # MA00-06200K would install. You could pretty easily draw out a 14 inch by 14 inch square on some cardboard and you'd basically have a template.

expert reply by: Jameson C

1

Answer 1

Hello Anthony. We definitely have a replacement vent option for you, but 2000 TS is not actually a model number or part number, so I do not have a way to look that up. Nonetheless, if you are looking for a replacement, I recommend the MaxxFan Deluxe…

view full answer...

Answer 2

Yes the Furrion Vision S Wireless RV Observation Camera Systems like part #FCE48TASL-05 and the TST TPMS for RVs part #TST-507-RV-4-C are perfectly compatible and will not interfere with each other. While they do both use wireless systems but use…

view full answer...

Answer 3

Hello Gary, When hooking up the Redarc MC4 Connector Kit for Solar Panels #RED98VR, 8 AWG wire will be too thick to fit properly. Instead, you'll want to use 11 AWG wire, which is the correct size for the SRC0001 connectors. I've attached an…

view full answer...

Answer 4

Both the smoke and white colors will be the same in regards to how much heat gets through and will be relatively similar when it comes to light, although the smoke will naturally be a little darker. Since you'll be using the roof vent AND a cover…

view full answer...

Answer 5

Hello Jason, thanks for reaching out. An Equal-i-zer Weight Distribution System is what I recommend for that since they are surge brake compatible. If you can tell me the GVWR or tongue weight of your camper I can recommend the correct WD hitch.…

view full answer...

Answer 6

You are right that the #MA00-06200K and the #MA00-07500K are very similar vent fans as far as most of the internal components. The main difference is that the 7500K uses a remote and has a powered lift. The 6200K is manual control and manual lift.…

view full answer...

Answer 7

The MaxxAir MaxxFan #MA00-06200K that you referenced is equivalent to a base model of the MaxxFan and it is only controlled by a keypad on the vent itself. If you wanted to connect it to your existing wiring then you would have to do some…

view full answer...

Answer 8

Hey Peter, what hanger dimensions do you need? What height from the mounting surface does the bolt hole need to be? With that I can see if we have a thicker gauge steel hanger option.

view full answer...

Answer 9

Hey Mark, thanks for reaching out, and congrats on the new camper! We have just the thing! Here is what I recommend: - Blue Ox SwayPro Weight Distribution w/ Sway Control for 2-1/2" Hitch - 15K GTW, 1.5K TW #BLU54TR The Blue Ox WD hitches are…

view full answer...

Answer 10

I do have some parts for you but we aren't custom trailer builders and adding electric to a trailer is not a simple task. What I can tell you is that most interior lights are 12 volt so if you want outlets, lights, and shore power you'd need…

view full answer...

Answer 11

If you're only wanting to setup AC service in your enclosed trailer then you could choose pretty much any 30 or 50 amp power inlet you wanted and then just run the appropriate gauge wire between the inlet and your panel. You can definitely…

view full answer...

How to Make Template to Determine Where MaxxAir Roof Vent MA00-06200K Would Install on Roof

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching