How Tight Should the Nuts be for Lippert Shock # LC283271
Updated 04/04/2017 | Published 04/03/2017
Question:
How tight should the stem nuts be or what percent should the rubber bushing be compressed?
asked by: Bob R
1
Helpful Expert Reply:
You will tighten the hardware for shock # LC283271 until the rubber grommets have the same diameter as the washers. They are close to the same diameter to begin with so be careful not to overtighten them.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Lippert Standard Replacement Shock - Black
- Accessories and Parts
- Trailer Suspension Parts
- Shocks
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Shock for Dexter Axle 052-003-00
- Q&A: Which Shocks Fit Dexter Axle on Trailer
- Q&A: Looking For Replacement For 013-143-03 Equalizer And Dexter Shocks On 2018 Cruiser 2916 RV
- Q&A: Length Of The Dexter Bolt-On Shock Kit # K71-697-00
- Q&A: Replacement Cushioned Equalizer Replacement for Dexter 13-143
- Q&A: Recommended Replacement For A Dexter Axle 052-003-00 Trailer Shock Kit
- Q&A: Measuring to Determine the Right Size Shock to Use on a Trailer
- Article: Most Popular Wheel Bearings
- Article: Brake Controller Installation: Starting from Scratch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Hitch Balls
- Article: Testing Trailer Brake Magnets for Proper Function