Does the Lockable Trimmer Rack Allow Bottom Trimmer to be Removed Without Interference When Loaded

Question

Question:

On your Lockable Trimmer Rack for Utility Trailers Item # RA-6RL,the video shows removing the top trimmer but can the bottom trimmer be removed with bumping or removing the one above it and not getting caught up on each other? Thanks

asked by: Jimmy

0

Expert Reply:

Yes, I spoke with my contact at RackEM and there was a design change which allows the arms on the Lockable Trimmer Rack for Utility Trailers # RA-6RL to fold down to a 45 degree angle. This will allow you to remove any of the trimmers on the rack while it is fully loaded.

expert reply by: Jon G

0

Answer 1

We do have the white Replacement Exterior Half-Moon Trailer Vent for 3" Diameter Hole #WHMAV2 which is the white version of the #HMAV2 that you referenced and also is what you sent in a picture of so it would work well for you.

view full answer...

Answer 2

Hello Nick, thanks for reaching out. The Dutton-Lainson Boat Trailer Jack #DL22335 may work for you. It has 7/16" holes. They are 5-1/2" apart across. There is 2-3/8" between the top hole and the hole under it. Then there is 1"…

view full answer...

Answer 3

Hello Nathan, thanks for reaching out. You are correct the Fulton XLT #F26ZR will not fit a 3x5 frame. We do have a few jack options in black that will fit a 3x5 frame. Take a look at the following: - Ark Xtreme Off-Road Swivel Trailer Jack w/ 2…

view full answer...

Answer 4

Hey Hank, welcome back. You can email that picture directly to the email you receive this response from. I saw you previously purchased the Dutton-Lainson Boat Trailer Jack item #DL22210. What you're describing sounds like the Replacement…

view full answer...

Answer 5

The EB01-140 and EB01-145 are Redneck Trailer Supply part numbers for a Dexter 12-1/4 x 3-3/8 7-bolt brake assemblies for a 9-10K axle. The proper replacements are available as part #23-450-451, which includes the left and right self adjusting brake…

view full answer...

Answer 6

The Peterson 426E is a grommet mount lamp which is 4 inches in diameter. We don't offer that particular lamp, but it cross referenced to several lamps offered by Optronics. Here's what's available: • #BU45CB is a in incandescent lamp that…

view full answer...

Answer 7

Hey Kevin! Welcome back. Since you have a 2025 Class C on a Ford E-450 chassis you need the Roadmaster Reflex RV Steering Stabilizer with Mtg Brackets #RM-RBK24-RSSC. This is specifically designed for Class C motorhomes built on the E-450 and…

view full answer...

Does the Lockable Trimmer Rack Allow Bottom Trimmer to be Removed Without Interference When Loaded

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching