Replacement Trailer Taillight Lens for Blazer DOT AIST 95

Question

Question:

Hi, this is the driver side photo. I broke the passenger side Blazer Dot AIST 95

asked by: Linda

0

Expert Reply:

The lens you need is part # A8RB. The light you have is a standard style trailer taillight and the lens part # A8RB is designed to fit it.

expert reply by: Jameson C

0

click to enlarge

Answer 1

In order to see if part #A8RB is the right replacement lens for your trailer tail light you can take a quick measurement. I have attached a photo of the #A8RB with the dimensions shown. As you can see the lens is 4-1/2 inches wide and tall and the…

view full answer...

Answer 2

We have just what you need. Thanks for sending in the picture as that made it very easy. You are in need of the part #A2RB.

view full answer...

Answer 3

Based on your photo it looks like you found the correct red lens #A8RB for your trailer's right-hand Optronics tail light #ST6RB. You can make double sure if you like by comparing the lens dimensions and mounting hole spacing shown the linked…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Replacement Trailer Taillight Lens for Blazer DOT AIST 95

Continue Researching