Replacement Roller Guides for Pontoon Boat Trailer

Question

Question:

I have a 2004 tracker trailstar pontoon trailer for a 24foot subtracted. I am needing to replace two of what I believe to be factory inside roller guides. At the bottom of post a u shape s over frame crossmember with one bolt running through. I cannot find anything online. Do you carry this part?

asked by: Willy G

0

Expert Reply:

We do offer a variety of pontoon boat trailer guide-on and roller products that you can see by clicking on the link provided. I reviewed photos of Tracker Trailstar pontoon boat trailers and noted some are equipped with post-style guide-ons like # CE27670 while others show roller-style guide-ons like # CE27672.

Please feel free to submit photos of your trailer if you have any trouble finding the replacement parts you need.

expert reply by: Adam R

0

Answer 1

There isn't an exact length of bunk boards that are required for pontoon boat bunks but in general around 75 percent of the length of the boat should be the length of the pontoons and you'll be good. So for a pontoon boat that measures 16…

view full answer...

Answer 2

Your 6.90-9 tires are an older style that we only carry replacement tires for - #AM10040, but I do have a solution for a close matching wheel and tire combination. Your current wheels/tires measure 21.1" in diameter; the closest we have to that…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Roller Guides for Pontoon Boat Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching