Do The Rear Jacks of the Lippert Ground Control Leveling System Mount to Inside or Outside of Frame
Updated 04/19/2016 | Published 04/17/2016
Question:
Do the rear jacks mount on the outside of the frame or the inside. I havent looked yet but the proximity to my bathroom gray water and blackwater tanks may be an issue. It would also be very close to the center of the underslung spare tire. Also, wouldnt it be easier to just cut access where you need it and reseal with a good waterproof tape. I think a good flat plumber snake would be able to fish the wire harnesses to the front where the underbelly pan is easier to lower. 2013 Montana Mountaineer 375FLF.
asked by: Scott M
Expert Reply:
The rear legs of the Lippert Ground Control 3.0 # LC358590 that you referenced mount to the outside of the trailer frame. I attached a picture that shows a typical install of the rear jacks.
In most cases no modification is needed to mount the rear jacks. I would doubt that you would have to cut up the body of your trailer to get the rear jacks attached.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Search Results: lippert camper jacks
- Video: How to Install the Lippert Ground Control 5th Wheel RV Leveling System - 2015 Forest River Vengeance
- Video: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System Installation - 2020 Forest River Ch
- Search Results: 50 amp breaker
- Search Results: 50 amp fuse
- Shop: Circuit Breaker - 50 Amp - Perpendicular Mount Bracket - Cycling Auto Reset - Plastic - Type I
- Shop: Derale Automatic Resetting Circuit Breaker - 50 Amp
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Mounting Plate Height of Replacement I-Beam Jack Bracket for Lippert Ground Control
- Q&A: How to Determine if Lippert Ground Control 3.0 Will Fit 5th Wheel RV
- Q&A: Can Rear Jacks of Lippert Ground Control be 24 inches From Rear Axle
- Q&A: 6 Point Automatic Leveling System Recommendation 2010 Keystone Montana Fifth Wheel
- Q&A: Installation Of The Lippert Ground Control 3.0 Jack Leg Mounting Brackets
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Trailer Hitch
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer jack
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
- Video: How to Choose a Trailer Brake Controller
- Search Results: trailer tires and wheels
