Is it a Good Idea to Replace Hub/Drum When Replacing Brake Assembly on Trailer
Updated 04/11/2016 | Published 04/07/2016
Question:
I was wondering if it is a good idea to replace the brake drum when you replace the brake lining? The drums show some wear from the magnetic. Thanks
asked by: Steven S
Helpful Expert Reply:
If there is visible signs of wear then it is a good idea to replace the hub/drum with the brake assemblies.
If the armature surface where the brake magnet is damaged, or if the area where the bearings ride is showing wear or is damaged it would be time to replace the hubs. If you had bearings go out in the hub and you continued to drive on them for a while, to the point where the hub is damaged it would be time for the hub to be replaced.
To pick out replacement hubs you will need to get the numbers off of the bearings plus the bolt pattern of the hubs. With that info we can pick out the correct hub. See the picture I attached for more info.
Product Page this Question was Asked From
Electric Trailer Brake Assembly - 12" - Right Hand - 5,200 lbs to 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- RH
- 5200 - 7000 lbs
- Brake Assembly
- Manual Adjust
- 12 x 2 Inch Drum
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: 12 Gauge 2 Conductor Jacketed (Brake) Wire Per Foot
- Shop: 14 Gauge, 4 Conductor Jacketed Wire - Per Foot
- Shop: 12 Gauge 6 Conductor Jacketed Trailer Wire Per Foot
- Shop: 14 Gauge, 7 Conductor Jacketed Wire - Per Foot
- Search Results: caliber trailer flooring
- Search Results: trailer flooring
- Search Results: plastic trailer flooring
- Search Results: aluminum trailer flooring
- Shop: Triplex Wire with Grey Outer Jacket - 14 Gauge - Black-Green-White - per Foot
- Shop: Parallel Multi Conductor Wire - 14 Gauge - Green-Yellow-Brown - per Foot
- Shop: Trailer Wiring Junction Box - 7 Color Coded Terminals - ABS
- Q&A: What Size Nuts and Studs are Used to Mount 7 and 10 Inch Trailer Brake Assemblies
- Q&A: Torque Spec for Tightening Trailer Brake Assemblies to Trailer Spindle
- Q&A: What Is The Torque Spec For The 4 Bolts On 10" Backing Plates
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Shop: Suspension Enhancement
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Shop: Brake Controller
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
on Accessories and Parts
