Dimensions of Ultra-Fab Drill Adapter Compared to a Stromberg Carlson Manual Crank Handle LG-119226

Updated 04/05/2016 | Published 04/02/2016

Products Featured in This Question

Ultra-Fab T-Slot Power Drill Adapter for Scissor Jacks

(73)

$13.31

Replacement Crank Handle for Stromberg Carlson Landing Gear

(38)

$36.94

Question:

Could this be used as an alternative to the LG-119226 manual crank handle. The Atwood drill adapter is too short for the T-slots to make contact.

asked by: Christopher S

Expert Reply:

I was able to go out to the warehouse and measure both the # UF48-979071 and the # LG-119226. I found that they are very similar but not exact, but it is still possible it could work for your setup.

The Stromberg-Carlson # LG-119226 has a shaft length of 2.343 inches, an inner hole diameter of .50 inches, and a .40 inch slot depth.

The Ultra-Fab # UF48-979071 has a shaft length of 2.5 inches, an inner hole diameter of .66 inches, and a .78 inch slot depth.

If this is compatible with the dimensions of your landing gear then this power drill adapter will work for you. I have linked the drill adapter as well as an image of the measurement on the drill adapter to this page for your convenience.