Cover Recommendation for a 2002 Fleetwood Niagara Pop Up

Question

Question:

Hi I have a fleetwood niagara coleman pop up trailer 2002 What is the size of cover that fit it????

asked by: Ruby

0

Expert Reply:

Your 2002 Fleetwood Niagara is 19 feet long so for a cover confirmed to fit this size you would want the part # CA80043 as it can fit popups from 18-20 feet in length.

expert reply by: Jameson C

0

Robert

6/3/2020

I ordered part # CA80043 for my 2002 Coleman Niagara and it is huge doesn’t even seem like it fits correctly yet your experts say it fits?

Chris R.

6/7/2020

I'm really sorry about this. Can you tell me the actual length of your trailer (not including the tongue)?

Answer 1

I spoke with my contact at Bargman and found that your SAE-A-P2-83 lenses were from the Bargman #59 series trailer lights, however, the #59 series lights were changed and the new replacement lenses do not fit the old style lights. The current red…

view full answer...

Answer 2

I recommend the Classic Accessories Deluxe PolyPro III Heavy-Duty Pop-Up Camper Cover, part #CA80038 for your 8 X 10 pop-up camper. This cover has corrosion-resistant grommets and draw cords that help to give a tight, secures fit and keep out rain,…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 9

Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…

view full answer...

Answer 10

To determine the correct size RV storage cover for your Coleman Lantern LT Travel Trailer you'll need to measure the body length. In the attached picture below you'll see exactly how to measure. Once you have this measurement you can choose…

view full answer...

Cover Recommendation for a 2002 Fleetwood Niagara Pop Up

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching