Can a 205/75R15 Trailer Tire fit a 15 by 6 inch Trailer Rim

Question

Question:

Will a 205 75R 15 tire work on this rim? I know I could buy the 15 X5 but want to go with 225 tires later so reason I want 15X6. Thanks

asked by: Larry

0

Expert Reply:

Yes, a 205/75R15 will fit a 15 by a 6 inch rim like the part # AM20522 that you referenced.

For a 225/75R15 for when you are ready the part # TTWTRTM2257515D would be a great choice.

expert reply by: Jameson C

0

Answer 1

The best way to measure the bearings is to use a precise measuring tool such as a dial caliper and measure the inner diameter of both bearings. You can also measure the bearing and seal journals on the spindle (see photo). Measuring the grease seal…

view full answer...

Answer 2

Thank you for the photo of your vintage utility trailer's spindle. The simplest and surest way to identify a compatible trailer hub is to identify the inner and outer bearings and the grease seal it uses. Matching up those components along with…

view full answer...

Answer 3

Wheel offset is very similar to backspacing and refers to the location of a wheel's rim in relation to the wheel's center. Most trailer wheels have a 0 offset, but to determine if the wheels on your trailer have one, you will first want to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Can a 205/75R15 Trailer Tire fit a 15 by 6 inch Trailer Rim

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching