How to Determine Wheel Bolt Pattern that the Dexstar Vintage Steel Rim part # AM20395 Would Fit

Question

Question:

Ill attach pictures to help.. I did the measurements against the lugs and the pattern is correct for this rim but I am unsure of the height. based on the tire can you tell if this is the correct Rim? ST205/75D15 ? Well I tried to attach a second picture but that didnt seem to work.

asked by: Kirk K

0

Expert Reply:

The Dexstar Vintage Steel Rim part # AM20395 that you referenced has a bolt pattern of 4 on 9.44 inches.

If the measurement you took was from the center of one wheel stud to the center of the one directly across from it and it was 9.44 inches then the # AM20395 would be the correct rim.

expert reply by: Jameson C

0

click to enlarge

Answer 1

We have the Dexstar Vintage Steel Wheel available in a 15"x5" #AM20395. Both use the 4 on 9.44" bolt pattern. We do have the Karrier ST205/75R15 Radial Trailer Tire #AM10244 and Westlake ST225/75R15 Radial Trailer Tire #LHWL304 that…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

How to Determine Wheel Bolt Pattern that the Dexstar Vintage Steel Rim part # AM20395 Would Fit

Featured Help Information

Miscellaneous Media

Continue Researching