Mounting Hole Dimensions for the 55" Lock Side-Door Bar Lock Assembly # 3057-55

Question

Question:

what is the length between the top hole and bottom hole on your 55inch pipe Lock Side-Door Bar Lock Assembly. Also what is the measurement on the lock handle to the top hole of the hinge. thanks

asked by: Randy S

1

Helpful Expert Reply:

I went and pulled a 55" Lock Side-Door Bar Lock Assembly # 3057-55 from our warehouse to get the dimensions you requested. The length from the top mounting hole of it down to the bottom mounting hole is 53-1/2 inches, the distance between the holes of the mounting brackets is 3-1/4 inches, and the distance from the center of the handle to the top mounting hole is 26-3/4 inches.

expert reply by: Jameson C

1

click to enlarge

Answer 1

If you have a bar style door like the part #3057-55 that you referenced on your trailer you could pretty easily replace it with the #3057-55. The hinges may match up but we don't know that for sure. You can check out the picture I attached that…

view full answer...

Answer 2

The spring with the black cable drum should always be mounted to your LEFT, standing on the inside of the trailer looking out. This is very important for proper operation. Dual spring systems, like #ERS160D96, have a red-coned and a black-coned…

view full answer...

Answer 3

The cables with the Conventional Ramp Door Springs like part #M394FR are attached to the door via anchor brackets which are included with the kit. I have attached below the excerpt from the install instructions below which goes over the cable…

view full answer...

Answer 4

I went and measured the mounting bracket of the 55" Lock Side-Door Bar Lock Assembly #3057-55 that you referenced and found that the actual bracket is 1-1/4 inches wide, but if you count the hinge portion that sits a bit above bracket the…

view full answer...

Answer 5

While we do not have any specific replacement parts we do have some options but you will need to replace the latch system (unfortunately the second picture you mentioned did not come through). For example, you may be able to use the 55" Lock…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

I do have an option for you but we don't carry Imperial products. That said, the Side-Door Bar Lock Assembly part #3057-55 would be an excellent replacement for this. The only real difference is the mounting pattern is not the same so some small…

view full answer...

Answer 8

Hey Ben, the deciding factor is really where your current jack mounts and whether you want it to stay in that same location. If your enclosed trailer already has a standard A-frame jack opening and you’re happy with the jack staying in the center,…

view full answer...

Answer 9

With your tongue weight at 1,175 lbs when loaded, you also need to account for any cargo weight behind the rear axle as well to get the total tongue weight rating. I've attached an article to assist. You are correct that your current system is…

view full answer...

Answer 10

Sounds like the brake controller is backfeeding 12 volts onto the brake light circuit of your RV. Check to see if the red wire of the controller is putting out 12 volts when all of the other wires are connected. If so, then the controller is bad and…

view full answer...

Answer 11

Hey Lexie, the closest thing we have is the #BA65FR. This fits cutouts that are 5-1/4" wide x 4-1/2" tall. The little bit of extra height on your cutout won't be a problem since the face is 5-1/2" tall and would cover the opening.…

view full answer...

Answer 12

To install the 55" Lock Side-Door Bar Lock Assembly #3057-55 you will need to use 5/16 inch fasteners. You will choose the hardware based on the material the assembly will be mounted to. If you used security Torx hardware then you would not…

view full answer...

Mounting Hole Dimensions for the 55" Lock Side-Door Bar Lock Assembly # 3057-55

Product Page this Question was Asked From

Continue Researching