2004 Mazda 3 Replacement Mirrors

We have both single and dual ramp spring sets and form my understanding it has more to do with the weight capacity than anything else. For your 85 lb ramp we have the Single Spring #362SA5 that fits a 5' wide enclosed…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A different amount of spacers is not needed between the left and right side of your 2016 Ford F-250 to install the Firestone Ride Rite kit part #F2703. I would make sure your truck is sitting on level ground, isn't loaded on…

I recommend going with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL89DQ for hauling around an in-bed camper with your 2024 Ford F-350 Super Duty. I really like this kit because it has the higher 7,500 lb rating (which you…

To add a 7-Way to your 2021 Ford Bronco you will need a 4-Way kit like the recommended T-One #TK99VR and then the Universal Wiring Kit #ETBC7. The T-One plugs in behind the tail lights of your Bronco and gives you the standard light functions while…

Yes, we have the K-Source Universal Towing Mirrors #KS69ZR which will fit your 2024 Toyota Tundra. These towing mirrors are easy to install, has mirror face dimensions of 7-3/4" tall x 5-1/8" wide,…

The tank that comes with the Air Lift WirelessAIR Suspension System for Air Helper Springs #AL27DQ is a 2-Gallon tank. When it comes to the physical dimensions, the tank measures 17" Long x 8" Tall…

That sounds right to me Travis, but while you have everything pulled out it wouldn't hurt to re-measure and double-check. The height shouldn't have changed and everything should essentially go as…

The AllTrek 4000 kits provide the best cushioning so if you were to upgrade from your CRE3000 kit to the Alltrek you would see a big improvement. If you have a 35 inch wheelbase you'd want the part #MR29DR or if you have a…

The brackets on the SumoSprings Trailer Helper Springs #SS26MV are 1-1/2" wide so they will fit evenly across the humps on your spring pads. I do not recommend cutting down the spring and you will be able to use these even…

For a trailer that has an angle iron frame like what you have what I would recommend is a system like the Reese Steadi-Flex part #RP66558 you referenced and have the outer brackets welded to the frame of the trailer since there…

I spoke to a representative from CIPA. He told me the mirror in the CIPA Universal Door Mount Truck and Van Mirror - Black, part #CM41100, is not removable. I have included a video demo link below.