1976 Chevrolet Headache Rack

Hey Elvin, I wasn't able to find any bracket kit for that light, but I was able to find the Ultra-Thin LED Strobe Light #3378892202 for amber and white lights, #3378892200 for just amber, or #3378892201 for just white lights, which can be mounted…

The install of the Aries AdvantEdge Bull Bar #AA89FB does require removing the factory tow hooks.

Hello Joseph, yes there is! What you are looking for is the Anti-Rattle Hitch Lock and Cable Lock for 2" Hitch Mounted Bike Racks #e88RV. This will work with the Benton Bike Rack #B54VR, as well as the #B94FR and #B54FR so that the bike and rack…

Good afternoon Nathan, that's a great question! You can use the etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers #e38FV with a 3" to 2" reducer adapter like Buyers Products 3" to 2" Receiver Tube Adapter…

Hi Mary, Do you leave the camper in the bed most of the time or does this truck spend a good chunk of time driving around without the camper? The SumoSprings Solo Custom Helper Springs #SSR-211-54 would be a great option if you leave the camper in…

Hello Dan, thanks for reaching out. The Firestone #F2550 for the 1999 Ford F-250 2WD will be compatible with the B&W Turnoverball gooseneck hitch. The brackets are designed specifically to be compatible with in-bed hitches like the B&W, so if…

For a 2003 Chevy Silverado 2500 6-1/2 foot bed we have the part # AA111000 which is a confirmed fit from Aries but the part number you mentioned will not work as it is designed for newer trucks. Another option similar in appearance that is a fit is…

The bed width didn't change between the year models so you shouldn't have an issue with fitment on the 2012 model. If you have the Aries Classic Headache Rack #AA111000 that you were looking at then I can confirm that this will fit the 2012…

Do you have a crew cab or a regular cab? Torklift is really particular with their fits but with that last bit of info I should be able to see what solution would work.

You're not "required" to use a jack and jack stands when installing the Curt #C13269 but when performing the installation without an additional set of hands it's never a bad idea to have something that you can use to hold the hitch…

To have a support, we normally use a second set of hands because that is the safest and easiest option. When another set of hands is not available, an option is to use the Ultra-Fab Slide-Out Supports for Motor Homes - 21" to 37" - Qty 2…

I'm not sure why they include that replacement latch but that is not required for any of the aftermarket hitches or wiring. It is probably something related to the installation of the OEM hitch. The etrailer #e45ZR you referenced is what I would…