Truck Grilles Specs:
Features:
Customize your vehicle with Putco's easy-to-install, stainless steel bumper insert. With its mirror finish and heavy-gauge, punch design, this durable, rustproof insert offers up the style that your ordinary, factory grille lacks.
Installation Notes:
No drilling required for installation
Product does not fit LTZ models
More Information >Videos
for Truck Grilles
Help Articles
for Truck Grilles
Expert Answers
for Truck Grilles
The BAKFlip MX4 Tonneau Cover #BAK48330 for the 2022 F-250 short bed has 4 panels. While you are using your Demco Autoslide 5th Wheel Hitch #DM8550024 you will be able to keep one panel laying flat on the bed. There are tow ways you can store the…
view full answer...The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV will be just fine if you need to lift your 2022 Ford F-250 Super Duty, but it will be good practice to lower the psi rating to 5 prior to lifting the truck. I confirmed this…
view full answer...You will want the hitch to be set at the height that 1) allows the trailer to be level, and 2) allows you a minimum of 6 inches between the bottom of the trailer loft and the top of the bed rails. The fifth wheel hitches offer several inches of up…
view full answer...When adjusting the arms of the #BWRVK3305, you have the option of setting up so the king pin will sit 3 inches forward or 1 inch forward of the axle. I'd set it up at the tallest height, 18-3/4 inches above the floor of the truck bed and 1 inch…
view full answer...You're going to want to go with the set of Timbrens item #TABSTOR4R you were looking at. The only SumoSprings available for the 4WD 2002 Toyota 4Runner are for the front end item #SS84PV. The Timbren Active Off-Road Bumpstops item #TABSTOR4R have…
view full answer...The Furrion 2-in-1 Range Oven with Glass Cover #FR97KR is actually really close to the dimensions of your 21 inch Magic Chef so this would be an easy and great replacement solution that would fit perfectly.
view full answer...I went out to our warehouse to measure the Valterra EZ Valve Double Electric Waste Valves part #E84-8 for you. The wire lead on the actual valve is about 8-1/2" long whereas the wire lead on the switch is about 7' long for each valve/switch.…
view full answer...Since you can be looking at a max weight capacity of 14K you need a tire rated for at least 3.5K so that it can accommodate up to that weight. For your application I recommend using the Kenda Karrier ST235/85R16 Radial Trailer Tire #AM10295 because…
view full answer...Great question! The 2 gallon container of EXP90 adhesive included with the LaSalle Bristol XTRM Roof Install Kit #3442703414KIT will cover about 400 square feet (200 square feet per gallon).
view full answer...To install a 7-Way harness on your 1996 Dodge Ram without the factory connector, you will need two separate wiring harnesses because they don't make just one that'll do the job. The first harness you'll need is the Curt T-Connector…
view full answer...The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…
view full answer...I spoke with my contact at Draw-Tite and he said using an offset ball will not significantly increase trailer sway on a gooseneck trailer. If you are experiencing sway, the best defense is proper trailer loading. If you can load your trailer so that…
view full answer...Filter Products (2)