2016 Ford Expedition Grille Guard

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine,…

Pace Edwards has two confirmed fitting Switchblade covers for your 2024 Chevy Silverado 3500 DRW 8' bed; part #PE87CV, which is an aluminum and vinyl mix and part #PE77CV, which is just aluminum.

There is a trailer hitch receiver as well as a 4-way wiring harness that fit your 2022 Jeep Grand Cherokee WL; that said, we don't have any way to reference a VIN so…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter…

The Replacement Hardware Kit #AABRKT-5056 will fit the Aries Pro Series Grille Guard #AAP5056. This is the upgraded version of the Grille Guard #AA5056 which uses the same install hardware to attach to a truck.

We do have replacement mounting hardware for the Aries Grille Guard on your 2008 Toyota 4Runner. If you have the #AA2058 the correct brackets and hardware are the #AABRKT-2058. If you have the #AA66XB then you need the #AABRKT-2066.

I have the answer you are looking for. From your part number provided, you are talking about the Pace Edwards Switchblade Retractable Hard Tonneau Cover. Unfortunately, the #311-SWC95A17 does not fit your 2022 Chevy Silverado 3500. However, we do…

The hub/drum you sent in a picture of is a Lippert 8,000 lb axle hub with an 8 on 6-1/2 inch bolt pattern designed for oil-bath applications. The correct replacement then is the #8-285-10UC3-A.

Hey Jerry, the install of the Aries Bull Bar part #AAB35-4015 do require you to permanently remove the tow hooks to install. It looks like the similar Westin Ultimate Bull Bar part #32-3645 does allow you to keep them though.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch.…