Result: Seal Cross Reference

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

The left side is the driver side, right side is passenger side. On a trailer brake assembly like #23-105 the arm that the magnet is on points to the front of the trailer and the magnet always will be on the bottom. I have included a picture that…

A brake magnet such as the one on the Hayes/AL-KO #185100 that you referenced or the brake magnet depicted in your photo does not visually look “worn out” and they do not have hole type wear indicators. If the inner coil of the magnet is exposed then…

If you look at the wheel cylinder of the brake assemblies part #23-399 and #23-398 you'll see the letters L and R stamped on them. The R means right hand side and L means left. I attached a picture that points out the letter. Right side means…

The easiest way to tell if a trailer brake assembly is installed on the correct side of the trailer is to pull the hub off and look at the actuating arm. The arm should be in front of the spindles on the side closer to the front of it. See attached…

The braking performance will not be very good if you install brake assemblies on the wrong side of the trailer. The left side assembly is the driver's side (if the trailer were a car) and the right side is the passenger's side. The actuating…

If nothing is noted on the axle or outside of the brakes for the front or rear, you can remove the front hub and take a look at the brakes. The magnet is always on the bottom of the assembly and the actuating arm for the brakes always bows toward the…

The Dexter 3,000 lb hubs use inner bearing #LM67048, outer bearing #L44649, and double lip grease seal #58846. We don't have all of these together in a kit but you can order them individually and you'd be set.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

When you test the 4-Way on the Curt T-Connector Wiring Harness, part #56016, at the rear of your vehicle, it should show now power on all 3 pins with the lights off. If you have the vehicle head lights on, you should have around 12 volts at the brown…

Bearing Buddy pumps grease into the center of the hub all the way back to the grease seal. A double lip seal should be used to prevent grease from blowing out the seal when added. When the hub and seals and bearings are first assembled, they should…