Hey Adam, thanks for reaching out. Yes, I think you can make the Yakima SkyBox NX Skinny #Y93QD and FrontLoader #Y02103 work together on your 2022 Honda HR-V. The SkyBox NX Skinny is 26-1/2" wide and the FrontLoader takes up about 7" of…
Hey Jonathon. Both the Yakima CBX XXL item #Y73QD and the Thule Motion 3 item #TH59PN are going to work with your 2025 Nissan Armada's factory crossbars. I recommend the Yakima CBX XXL Rooftop Cargo Box item #Y73QD. It's been specifically…
Hello Heather, I am happy to help, but I am going to need a little more information about your setup before I can recommend the right cargo box. For your 2024 Toyota 4Runner, I would replace the factory crossbars with the Thule WingBar Evo Roof Rack…
Hey Gary, so if you can take one roof rack measurement on your 2018 Honda CR-V we can determine if the Thule Motion 3 #TH77PN will allow the rear hatch to open. Measure from the center of the front crossbar back to the rear hatch seam. If that…
You bet, Alan. That’s exactly the kind of versatility the Yakima SkyBox NX Skinny Rooftop Cargo Box (Black Carbonite) #Y93QD is designed for. Since its only 26-1/2inch wide, it leaves enough room on most standard crossbars like a 54inch or 60inch bar…
Hey Matt, thanks for reaching out! Here are the internal dimensions for those cargo boxes you asked about, as well as a snapshot of the whole file that Yakima has on their website (and a link to it!) concerning box sizing: - Yakima CBX LG #Y63QD -…
Thank you for the information! It sounds like your 2020 Toyota 4Runner TRD Pro has the raised rails and OEM crossbar setup that we'd find on the standard 2020 Toyota 4Runner. This has very low clearance under the factory crossbars so it's…
Good question Matt, you've definitely done your homework! Yes, your understanding is correct. The Replacement Fast Grip Clamp #TH94JV is the same mounting clamp used on the Thule Pulse Large cargo box #TH615. The FastGrip clamps are designed to…
Hello Mark, thanks for reaching out. Both the hitches you mentioned, the Draw-Tite #DT73RR and the Blue Ox #BLU92UR are a confirmed fit for the 2024 Subaru Outback. Both hitches also use the same size spacer and may require enlargement of the access…
Hey Scott, welcome back! Tthe Thule Motion 3 cargo box part #TH59PN is a really great larger roof cargo box that will work great on your 2024 Subaru Outback Wagon. This has 21 cubic feet of storage space which is a bit on the larger side but if…
Hey Larry, the warranty of just the membrane of the PowerMax Membrane Plus RV Roof Replacement Kit #PM73VR is 10 years. That does not cover the labor, adhesives, sealants/caulking, or underlying wood substrate. What camper are you planning on using…
For your 2022 Mazda CX-5 I recommend the Thule Force XT Sport Rooftop Cargo Box - 11 cu ft - Black AeroSkin item #TH6356B. The Thule Force Cargo Box will fit onto crossbars with a maximum width of 3-1/2 inches and height of 1-11/16 inches. The…
Very helpful/friendly Customer Service. Competitive Pricing. Shipping was Fast.
John
Mankato, MN
Roof Box with Large Capacity and Extra Long Length
Pack more without cramming the cabin—large capacity roof boxes in extra long length handle bulky duffel bags and keep clutter out of the interior. That extra long length can reach toward the windshield, so confirm your crossbar position and spread, and make sure your garage clearance works if you leave it on for ski season. Mounting is straightforward, and wind noise has been barely noticeable when set up right.
Possibly, but confirm total height first. Check the height above the crossbars to the top of the box from the manufacturer and add your roof-to-crossbar height. Compare that to your garage opening. If you see conflicting dimensions, use the manufacturer's height-above-crossbars spec.
Some install and remove without tools. A buddy helps since the size can be awkward to handle. During setup, open and close the lid gently and check hinge operation to avoid stressing the hardware.
It can extend past the windshield, so measure before you buy. Measure from the center of your front mounting points or front crossbar to the start of the windshield. Note your crossbar center-to-center spread to see where the feet land. Compare these to the box's mounting positions to estimate any overhang.
Yes, a slight bow/curve in factory crossbars wouldn't be an issue. Make sure the box sits fully on the rails with no part hanging off. Verify your crossbar spread matches the box's required range before mounting.
Sometimes, but verify the mounting surfaces. Many newer boxes have indented mounting clamps and not a flat bottom, which can limit compatibility with some platform racks. Ensure the box's clamp design can seat properly on your rack before purchasing.
Filters
