RV Plug Adapters - Adapter Cord, Camco

Hey David, we have the replacement screen for the Maxxair II vent with the part #MA10-20121 that you referenced but we do not have the frame as well. If the frame is damaged as well you'd need to replace the entire lid cover with the part…

Hi Nick, great question. Yes! The Air Lift LoadLifter 7500 XL part #AL89DQ will work great with your in-bed B&W Turnoverball hitch. They install in separate locations, so there won’t be any interference so you’re good to go there. Out of…

To ensure that the Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY58GR you will want to verify that your 2019 Keystone Cougar 315RLS does have 1621 pin box. The easiest way to confirm this is by the sticker that is on the top of the…

Coupler #CA5100B measures 9-1/4 inches wide at the widest part. I have included a picture showing some dimensions for you. For coupler #CA5400 is measures 11 inches wide at the widest point. I have included links to the video reviews of these…

The pipe diameter the ##PLR558-105 is designed to fit is 1-5/16 inch.

Hey Travis, thanks for reaching out! You'll definitely want to apply grease to the gooseneck hitch ball whether you're towing a gooseneck trailer or your 5th wheel with the Gen-Y Adapter Box #GY72SB. I spoke with Gen-Y and they said they…

Hey welcome back, Jody. So your best option here will be to get a new 50 amp surge protector for your new travel trailer. If you did end up at a camp ground with 50 amp service you would want to have it. I know a lot of sites do have just 30 amp but…

Hello Mike, Sounds like you are getting things set up the right way and not going over your payload, I respect that. It looks like the weights are the same whether you have a 6 3/4' or 8' bed. If you happen to have an aftermarket hitch,…

We do have 6-Pole Square Trailer Wiring Connector Kit (Car and Trailer Ends) #37995 that you can use for your Arctic Fox camper. This is both the male and female ends. But the wires on them are 18 gauge. You could replace the ground and power wires…

Hello Jacob, thanks for reaching out. There are a lot of different locks that can work with the Demco Ez-latch coupler. To be honest, any lock can be defeated, it is just a matter of how difficult the lock would be to defeat. A really good all-around…

According to Lippert that is a 6,000 lb hub and drum assembly with a 6 on 5-1/2 bolt pattern using #25580 inner and #15123 outer bearings. You do not need to use a replacement part from the same manufacturer so for a replacement you can use the…

Hey Ana! That picture doesn't look like much fun, hopefully the only thing that got damaged here was your transfer switch. The 2005 Ford Miranda Motorhome #PD5110010Q will work as a replacement for your motorhome since it is also 30A. Also yes,…