Dial in your site faster with manual levels that you can mount on your RV where you can see them from the cab or mirror. Choose drilled installs on a pin box or body, or go stick-on with tape or Velcro to avoid holes. Pick graduations in inches or degrees to match how you like to measure side-to-side and front-to-back.
Plan on drilling through tough steel and test your drill size. One installer found 3/16" a bit snug and 13/64" fit the bolt well when drilling 1/4" steel, using machine oil. Adding a washer to each bolt can provide extra support. Level the camper first and, if the level lacks built-in adjustment, use an adjustable mount to fine-tune.
No, some manual bubble levels are totally sealed and don't allow adding or removing fluid. There's no fluid maintenance required on those designs. If fluid level concerns you, confirm whether the specific level is sealed before purchase.
Yes, several manual levels can be attached with adhesive. Double-sided foam tape or Velcro have been used; a solid-backed housing helps, and some folks fill an open back with epoxy before using Velcro. Larger rear-view graduated options are typically screw-mounted, while stick-on graduated options tend to be in the 3 to 4 inch range. Clean the surface well before applying adhesive.
Both are available. Some manual levels use degrees, while others show inches from level. If you want to know how much to shim, pick inches. If you prefer angle reference, choose degrees. Check the product description for the graduation type you want.
Mount where you can see it from the truck cab or driver's mirror to cut the guesswork. Set the trailer level first, then align the bubble. Having a partner helps. Follow the directions—proper setup matters for accurate front-to-back and side-to-side readings.
Filters
