Under Seat Storage Specs:
Features:
...are covered with a soft material - won't damage firearms Holds 2 guns (1 of these with a scope) Large bin extends under both rear seats Special dividers organize your cargo Inserts help to separate smal...
Installation Notes:
Does not fit models with factory subwoofer under rear seat, unless subwoofer is removed
Metal factory trays under the seat will need to be removed for installation. These can be interchanged if needed
Designed for vehicles without factory navigation system
Product comes with 2-piece foam gun rack/organizers
More Information >Under Seat Storage Specs:
Features:
...are covered with a soft material - won't damage firearms Holds 2 guns (1 of these with a scope) Large bin extends under both rear seats Special dividers organize your cargo Inserts help to separate smal...
Installation Notes:
Metal factory trays under the seat will need to be removed for installation. These can be interchanged if needed
Designed for vehicles without factory navigation system
Does not fit models with factory subwoofer
More Information >Videos
for Car Organizer
Help Articles
for Car Organizer
Expert Answers
for Car Organizer
It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…
view full answer...Hey Paul, I spoke with Curt and they stated that the Replacement Trunnion Spring Bar for Curt TruTrack Weight Distribution System #C17535 would only be compatible with the #C17499. The Curt TruTrack 4P Trailer Mounted Weight Distribution System w/…
view full answer...What you are wanting to do is very possible with the GO Power Solar Panel kit part #34273836. You could mount it on your pin box and then run the wiring to your batteries via an SAE connector. We don't have an SAE connector…
view full answer...Depending on how your Topkick is equipped, you may need up to 3 items to install a brake controller. If the vehicle does not already have a trailer wiring harness you will first need to install a 4-way wiring harness. Since you seem to have a…
view full answer...The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158…
view full answer...I have spoken with Lippert about the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC675817 in they past and they informed me that the most important aspect is that the battery/batteries are sufficiently charged, between…
view full answer...If you need 18 feet of E-track I recommend using 2 pieces of 8 feet Horizontal E-track part #E19135 and 1 piece of 2 feet E-Track part #EM59150. 8 feet is the longest Horizontal E-Track available. The E-track pieces are not designed to be mounted…
view full answer...The best way to determine the weight capacity of your leaf springs would be to check the weight rating of the axle on your trailer. The trailer will have a plate or sticker on it that will list the VIN number. The weight rating of the axle should…
view full answer...As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…
view full answer...I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the…
view full answer...I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine,…
view full answer...