Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems. You can choose from the following based on color and ducted/ductless:
-Furrion Variable Speed Chill Cube RV AC w/ Heat Pump - Ductless - 18K Btu - White - R32 # FR87TQ
-Furrion Variable Speed Chill Cube RV AC w/ Heat Pump - Ductless - 18K Btu -... view full answer...
Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item # LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing cutout.
To swap out a Dometic AC with one of the new Furrion Chill Cube units, you'll have to swap out your air distribution box because anything made before 2025 isn't compatible anymore due to the new R32 refrigerant. Since you have a ducted system you will... view full answer...
Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below:
Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to 26-3/4" Lift - 2 Tons - item # PM44FR - weighs 15.24 lbs
Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons - item # PM34FR - weighs 27.09 lbs
Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons -... view full answer...
Hi Duane,
Air Springs are better for leveling loads and will typically give you a rougher unloaded ride quality so these might not be the best option for your setup depending on what your intended use is. Air springs are the best option when it comes to leveling the truck back out after placing it under a load so if you're planning on hauling a variety of items in the bed or towing multiple trailers they would have the most adjustability. If you're only towing occasionally and ride comfort... view full answer...
Hi JD; the Furrion Chill Cube # FR49TD air distribution box has a vent on it you can open and close. See the picture attached below. When it is closed it forces more of the air through the ducted system.
Assuming you have a ducted system you will need one of the following:
-Furrion Chill Cube RV Air Conditioner w Air Distribution Box - Ducted - 18,000 Btu - Black # FR39TD
-Furrion Chill Cube RV Air Conditioner w Air Distribution Box - Ducted - 18,000 Btu - White # FR99TD
-Furrion Chill... view full answer...
Hello Nathan ,
Looking to switch to the Furrion 18K, great choice! This year, new regulations were introduced for RV air conditioners, requiring a change from R-410A to R-32 refrigerant. This change helps reduce environmental impact and improves efficiency, a win for everyone! Since all AC units have been updated, you'll need a complete new setup in order for the parts to work. To make the switch, you'll want to order (3) of the Furrion Chill Cube RV Air Conditioner w/ Air Distribution... view full answer...
Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube # FR69TD (white) or # FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we have found that the included wall thermostat isn't always compatible depending on the furnace you have.
My recommendation is to get the # FR39TD (black) or # FR99TD (white) and then add a separate thermostat like the Dometic Digital Thermostat... view full answer...
Hey Ian, great to hear from you again!
The differences between the MORryde CRE3000 # MR87ZR and AllTrek 4000 # MR89DR that fit a 33" wheelbase is the height between the hanger and equalizer bolts, and the amount of travel the suspension style will offer.
For the CRE3000 the height distance is 3-1/4" and it can have up to 3" of travel, while the AllTrek 4000 has a 4-1/2" height distance, and it can have up to 4" of travel.
I personally like the CRE3000 a little better so I recommend going... view full answer...
No long-term contract, Natalie - but a service plan is required to use the trackers.
When you buy the 3000 with wifi assist # PM84FR, 5000 # PM64FR, or 5000 with wifi assist # PM74FR from etrailer, you’re purchasing the hardware/device only. To activate tracking, you’ll scan the included QR code and set up a monthly service plan directly with PingMaster through their app. There’s no long-term commitment, but the tracker won’t report location or alerts without an active plan.
If you’re... view full answer...
Hi Donald!
The MouseBlocker PROx Plug In Electronic Rodent Deterrent - 110V AC # MB34FR is rated to protect up to 400 square feet. However, it is mostly intended for direct protection and not necessarily a large area. Think vehicles, trailers, and even some Class A motorhomes (depending on their size). That kind of thing.
What are you thinking about using this for? Other than keeping pesky rodents away, of course. view full answer...
To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts:
Redarc Tow-Pro Liberty Brake Controller item # RED24FR
Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item # RED99FR
Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob item # 331-TPSI-002
You don't need a mounting bracket to mount the main control unit. It comes with slots in the sides for zip tying it some where convenient. It weighs... view full answer...
Hi Jeff,
Nice choice with the 100 amp hour Go Power Lithium RV Battery # GP99QR as well as the Expansion Kit # 34282182. Also, you can absolutely replace your PD9260 with the PD9360 model that is compatible with lithium batteries, and our part number for that is the following:
- Progressive Dynamics 9300 Series RV Converter Charger - 12V - 60A # PD79RR
This is both a reasonable and quality upgrade to work with the lithium batteries. Then, to answer your last question, you do not need... view full answer...
Hello Barry,
Since you already have a weight distribution (WD) hitch and are only experiencing a little rear sag, I recommend going with SumoSprings. I typically only suggest Timbrens for those who are towing heavy loads regularly, as they can create a noticeably harsh ride when the vehicle is unloaded.
Given that the sag is “not much but noticeable,” the SumoSprings Custom Helper Springs Rear Axle # SS46PV (blue) should be a great fit. These are rated for 1,400 lbs, while the yellow... view full answer...
Hey Dusty! There is a lot of information out there right now about Chill Cube. Some of it is definitely confusing, especially when we have people trying to use parts that aren't designed for the new R32 systems. On top of that, the Chill Cube uses a remote which acts as its thermostat and isn't compatible with a furnace.
There are two ways to make everything work together, I will give you both. The first is to get the Furrion Chill Cube RV Air Conditioner w Air Distribution Box - Ducted... view full answer...
We do carry the 33" Ark Stabilizer Jack that you are looking for with part # ARK77FR.
I was able to track down a few drawings that you should find helpful. These are for the 30" # ARK94FR and the 24" # ARK34FR Stabilizer jacks. I'm afraid we don't have a drawing for the 33" jack. view full answer...
The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package # BWRVK3775 you were looking at has four puck style feet that drop into the pucks and a lever on each leg that simply turns to lock or unlock the leg in the puck.
The prep package will typically also... view full answer...
Hey Kevin! The Draw-Tite Hitch item # DT66KV is going to sit higher than the Curt Hitch item # C89RV when it is installed on the 2024/2025 Chevrolet Equinox EV. The crosstube mounts behind the rear bumper instead of to the bottom of the frame so the receiver is going to stick out just below the trim.
There will need to be some trimming done to get the receiver of the Draw Tite item # DT66KV to stick through the fascia. I have attached a screen shot from the installation instructions below... view full answer...
You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller # C24VV.
The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under your dash. Screws are also included and you can use them with the adhesive to mount the bracket under your dash. Then you'll simply slide in the TriFlex NEXT controller and that's it.
This type of bracket takes up less space than the normal U-shaped... view full answer...
We do now have the EcoHitch Stealth Trailer Hitch Receiver # EH75SR which is confirmed to fit your 2022 VW GTI. This will have the removable 2" receiver opening. view full answer...
Go To Results