To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Heavy trailers and bed loads can make your rear end sag and throw off steering and braking. The SuperSprings Suspension Stabilizer and Sway Control Kit adds up to 1,900 lbs of extra support above your factory leaf springs to keep your ride level and steady. It automatically engages when the stock springs flex, lifting the rear enough to prevent bottoming out and helping distribute weight evenly through the suspension.

Strong crosswinds, big-rig turbulence, and cornering weight shifts won’t push you around as much with these helper springs in place. Acting like sway bars, they reduce sway by up to 30 percent by stabilizing your OEM springs and keeping them from twisting under pressure. That means steadier handling on highways, mountain passes, or uneven roads, with less rocking when a trailer or load starts to move.
Forget crawling under the truck to tweak air pressure or fittings. These helper leaf springs respond automatically to whatever payload you’re carrying—no tubing or air to monitor. The rollers at each end activate only when the springs flex under load, then deactivate when unloaded, giving you a quiet, consistent ride without extra upkeep.
You get several setup options right out of the box. Mount the shackles using upper bolt holes for greater load support and ride height, lower holes for near-factory comfort, or a mix for balanced support and smoothness. The bolt-on design installs above your existing springs with no drilling required, extending the life of your brakes, tires, and suspension while keeping ride quality where you want it.

For setups with OEM leaf springs above the axle, this kit includes a special mounting package with 2-inch brackets that act as silent fulcrum points. The design keeps preload tension low so you get quiet operation when unloaded while still gaining stable load handling when weight goes on. If your factory spring stack measures more than 2-3/4 inches thick above the axle, longer 5-1/4 inch U-bolts (SS112219-4) may be needed to complete installation.


Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're going to be taking a look at the SuperSprings lines of custom suspension stabilizer and sway control kits. You'll want to use etrailer's fit guide to determine the correct kit for your vehicle. Here's what our SuperSprings are going to look like once we have them installed. Now these are going to give us the support we need whenever we're hauling a heavy load or towing a heavy trailer. Typically, whenever we're hauling something extremely heavy our suspension wants to flex a lot and our back end sags down. Well these are going to provide us the extra support by activating whenever our suspension flexes, the rollers on the end of our leaf spring are going to activate our helper spring and provide us that extra support.
But also still giving us a nice ride when we're not towing something heavy, because it's going to deactivate those springs and still have a nice comfortable ride.And since they are attached to the front and back of our factory leaf springs, it's also going to act like a sway bar and it's going to prevent our leaf springs from twisting. Giving us a lot more stability when we're driving down the road. The multiple notches in the end here are going to provide us with a little bit of customization, depending on how much support we need. If we need more or if we just have a little bit of spring fatigue in our truck, it'll give us that little bit of lift so whenever we're towing something we don't have quite as much sag.We have a water tank in the bed of our truck as a heavy load or to simulate the tongue weight of a heavy trailer or a fifth wheel. So as I take the truck through my test course, I can definitely tell that there's a load back there.
The engine doesn't seem to be straining that much, but the bumps are extremely harsh and I can definitely feel it resonating through the seat. When I come to the slalom course and I'm going through the turns it definitely has a lot of body roll and I just generally feel like I need to slow down because it feels like it's leaning a lot and it's not responding quickly enough to the turns.The SuperSprings installed and I have the same load back there. When I'm driving through our course I can immediately tell a difference. The bumps aren't as harsh because the truck isn't sagging down as much and there's a little bit more support back there. But really where I tell a big difference is through the slalom course.
It definitely feels way more stable and even taking the turns going in and out, it just feels like it really wants to stick to the ground a lot better and just generally wants to go faster.Compared to airbags, these are a maintenance free option with no tubes to run or air pressure to maintain. Similar to airbags you can customize the level of support provided. Unlike airbags however you do this during the installation and set it one time rather than on the fly adjustability you get with airbags.And that completes our look at the SuperSprings line of custom suspension stabilizer and sway control kits.
Ratings & Reviews

Mike L.
2/8/2019
If you look at page 4 of the instructions which Ive linked for you, you can see photos showing a single leaf spring set up just like whats shown in the photos you provided thanks for the photos!. Im guessing that page was not included in your instructions for some reason.
Helpful Links

Timothy
2/9/2020
Springs are working wonderful after I figured out the install,. The initial problem was all my fault for being a man and not really reading the instructions haha. All is well

Brooke M.
6/11/2025
That's awesome, Douglas! Great to know these have been the solution you were looking for. The Timbrens are known to be pretty stout for sure. I can totally see how these would have the right amount of give needed to support the camper and have a smooth ride :) Have you taken out the truck and camper recently?

Conrad
8/19/2021
After about one year, these are still working great. I typically use my truck for pulling my 5th wheel. But - even when empty, you dont really feel anything different. When the camper is on, it sure levels the truck and camper out perfectly, giving you a great ride.

Victoria H.
11/11/2024
Hi Chris, there should've been a hardware kit for suspensions with leaf springs that sit above the axle. Please let me know if this is the hardware kit that was missing, and I can help you get this resolved.

Larry P.
10/3/2022
They work great, they improved the rear suspension so there is no more bottoming out when I pull the 5 wheel Rv .

Mike L.
10/1/2026
UPS is currently doing an investigation, once they figure out what's going on we'll get you an update. I'm very sorry for the delay.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.









Howard
11/9/2020
One Year later still no sag.