Stay visible when towing your boat trailer at night with this submersible, 1" diameter LED light. This amber light functions as both a front side marker and clearance light. PC rated. 18" Long pigtail.
Features:
Specs:
Maintaining a functioning lighting system for your boat trailer is required by law. Make your life simpler by installing lights that you can trust be to be submerged regularly. The housing and lens of this light are sealed together to create a single unit, which means that water will not get into the light to damage the diode or circuit board. Also, a special urethane potting is used to encapsulate the circuit board, further ensuring protection from moisture and dust.
A PC-rated light produces a 90-degree angle of light on either side of its centerline for a total of 180 degrees of coverage. This beam pattern can be clearly seen when you are standing directly in front of the light, as well as when you are standing on either side of the light. Rather than buying side marker and clearance lights separately, you can mount this single, PC-rated light at a 45-degree angle on the front corner of your trailer to act as both.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at this TecNiq recessed mount, mini amber LED, side marker trailer light. Now, this is a nice, small, round LED light that'll serve as a side marker and clearance light for your trailer. It's in a nice sealed waterproof housing and lens unit, and it is IP 68 rated. Does offer military-grade construction of the circuit board, and it uses urethane potting, which offers better protection than the common epoxy potty.
The LED is a premium LED. It is energy efficient, long-lasting and vibration resistant. It is rated for up to 100,000 hours of operation. The lens is a durable UV resistant lens, and it is an amber lens over one amber LED. Now, this is compatible with 12 volt DC systems.
It is a recessed mount installation. Comes with the included grommet for installation, and it will require a 3/4 inch diameter cut-out for this to install in. Now, you can add a stainless steel trim ring for a nice finished look if you'd prefer. We do sell them separately on our website and they're listed on this product page as a related product. This is a two wire harness which will hardwire to your application.
It includes a white ground wire and a black power wire. Total wire length on this is about 18 inches. It is a PC-rated light, so it will produce 180 degree beam when properly installed. And this does meet or exceed the Federal Motor Vehicle Safety 108 Standards. Now, I'm gonna hook this up to some power to show you how bright the light is.
First, I wanna give you dimensions on it. The diameter of it is right at one inch. The depth of it, front to back is right at 7/8 of an inch. Input voltage, nine volts to 14 volts. And the power draw is only .03 to .06 amps. So, we're gonna go ahead and hook up our ground wire and then we'll hook up our power wire. And you can see once it's hooked up and the power's on, it gives you a nice amber light. We'll go ahead and turn off our, and it's a single LED over, with an amber lens over it. So, you can see it gives off a very bright amber light. And I'll go ahead and turn back on our overhead lights then turn off our power. But that should do it for the review on this TecNiq recessed mount, mini amber LED, side marker trailer light..
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.